Kemppi MinarcTig Evo 200 Service Manual
Also see for MinarcTig Evo 200: Operating manualQuick guideQuick start guide
                           | |
Contents
| 
Service manual MinarcTig Evo 200 Version 1.1.5. 29.9.201522Kemppi Oy4.2.2. A001 control cardControl card voltages +5VDC and +24VDC can be quickly verified with LEDs on the A001 control card.Voltages are in secondary side.4.2.3. Cooling fanCooling fan gets the power from +24VDC line. Voltage can be measured on the X13 connector (X13-1+24VDC and X13-2 GND). Note that the cooling fan has delayed starting.4.2.4. Low voltage testsThere is no possibility to do low voltage test for this machine.4.2.5. Safety testsSafety tests are made normally. Note that PE conductivity test point and chassis ground test point is ingas valve snap connector.4.3. Semiconductor installationIt is a must to use torque screwdriver while tightening any power components onto the heat sink.See following sections for tightening torques.4.3.1. Rectifier/PFC module and IGBTMinarcTig Evo 200 has a soldering input rectifier/PFC and IGBT modules and it is not possible to changethem separately. Only reliable way to replace the module(s) is to change the whole Z001 main circuitcard.H2 +24VDCH1 +5VDC |
Related manuals for Kemppi MinarcTig Evo 200
Kemppi Minarc Evo 150 Service Manual
Kemppi MinarcTig EVO 200 Quick Manual
Kemppi MinarcTig 180MLP Service Manual
Kemppi MinarcTig Evo 200 Quick Start Manual
Kemppi MinarcTig Evo 200 Operating Manual
Kemppi Minarc 150 Service Manual
Kemppi Minarc Mig Evo 200 Operating Manual
Kemppi KEMPOMIG 3200 Service Manual
Kemppi MasterTig AC/DC 2000 Service Manual
Kemppi KM 300 Service Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine