Kentec Electronics Sigma XT K11031F2 Operation And Maintenance Manual

Kentec Electronics Sigma XT K11031F2 Operation And Maintenance Manual Manual pdf 40 page image

Product Manuals/Man-1088_Sigma XT_26 Page 40 of 4024. Commissioning instructions24.1Before applying power to the panel, the extinguishant device (solenoid or igniting actuator) mustbe physically isolated from the system by disconnecting both wires to it. This will prevent anyaccidental release of extinguishant.24.2When power is applied, if all connections are correct, only the green Power On and either theAutomatic and Manual or Manual Only indicators should be lit.If any fault indicators are lit the wiring to the appropriate input or output should be checked an allfaults cleared before proceeding.24.3Once the panel is fault free, it can be configured with the desired options as described in section 17.24.4Once the panel has been configured the system should be thoroughly tested to ensure that thecontrol panel responds as expected and required.24.5After satisfactory testing, any final connections should be made (such as to the extinguishantrelease actuator).24.6A record of the configuration options that have been set should be recorded in the table on section22 and this manual provided as part of the documentation recommended by BS5839:Part 1:2002section 40.2 b).

/ 40

Related manuals for Kentec Electronics Sigma XT K11031F2