Kenwood 86120-YZA59 Owner's Manual

Kenwood 86120-YZA59 Owner's Manual Manual pdf 9 page image

English | 9Bass levelAdjustment Item Display RangeBass Center Frequency "BAS F" 40/50/60/70/80/100/120/150 HzBass Q Factor "BAS Q" 1.00/1.25/1.50/2.00Bass Extend "B EX" OFF/ONMiddle levelAdjustment Item Display RangeMiddle Center Frequency "MID F" 0.5/1.0/1.5/2.0 kHzMiddle Q Factor "MID Q" 1.0/2.0Treble levelAdjustment Item Display RangeTreble Center Frequency "TRE" 10.0/12.5/15.0/17.5 kHz5 Exit the Detail Audio Control modePress the [VOL] knob for at least 1 second.• When you set the Bass Extend to ON, low frequencyresponse is extended by 20%.• You can exit the Audio Control mode at anytime bypressing any button except for [VOL] and the [ATT]buttons.Audio SetupSetting the Sound system, such as Cross overNetwork.1 Select the source to adjustPress the [SRC] button.2 Enter Audio Setup modePress the [VOL] knob for at least 1 second.3 Select the Audio Setup item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Setup the Audio itemTurn the [VOL] knob.Adjustment Item Display RangeFront High Pass Filter "HPF" Through/40/60/80/100/120/150/180/220 HzRear High Pass Filter "HPR" Through/40/60/80/100/120/150/180/220 HzLow Pass Filter*1,2 "LPF" 50/60/80/100/120/Through HzSubwoofer Phase*1,2,3 "PHAS" Reverse (180°)/ Normal (0°)Volume offset "V-OFF" –8 — ±0Loudness "LOUD" OFF/ON• Volume offset: Sets each source’s volume as adifference from the basic volume.• Loudness: Compensates for low and high tonesduring low volume.• * 1 You can control this item when (page 21) is set to "SWPRE SW".• * 2 You can control this item when Output> (page 11) is set to "SW ON".• *3 You can control this item when Low pass filter is notset to Through.5 Exit Audio Setup modePress the [VOL] knob for at least 1 second.