Kenwood CD Receiver Instruction Manual

Also see for 00271-13000: Instruction manual

Kenwood CD Receiver Instruction Manual Manual pdf 28 page image

English— 28 —The use of any accessories except for those provided might result indamage to the unit. Make sure only to use the accessories shipped withthe unit, as shown above.1. To prevent a short circuit, remove the key from the ignition anddisconnect the - battery.2. Make the proper input and output wire connections for each unit.3. Connect the wiring harness connector to the unit.4. Install the unit in your car.5. Reconnect the - battery.6. Press the reset button.AccessoriesInstallation Procedure2 4External view......... Number of itemsExternal view......... Number of items.........43.........21.........4 .........2If you connect the ignition wire (red) and the battery wire (yellow)to the car chassis (ground), you may cause a short circuit, that inturn may start a fire. Always connect those wires to the powersource running through the fuse box.• If your car's ignition does not have an ACC position, connect theignition wires to a power source that can be turned on and offwith the ignition key. If you connect the ignition wire to a powersource with a constant voltage supply, as with battery wires, thebattery may die.• If the console has a lid, make sure to install the unit so that thefaceplate will not hit the lid when closing and opening.• If the fuse blows, first make sure the wires aren’t touching tocause a short circuit, then replace the old fuse with one with thesame rating.• Insulate unconnected wires with vinyl tape or other similarmaterial. To prevent a short circuit, do not remove the caps onthe ends of the unconnected wires or the terminals.• After the unit is installed, check whether the brake lamps,blinkers, wipers, etc. on the car are working properly.• Mount the unit so that the mounting angle is 30° or less.• Don't do remodeling of this unit and the change of the terminalconnection.2CAUTION2WARNING