Kenwood CS-7070ES Instruction Manual

Contents

3 ENENGLISHOn the WallThis speaker include mount hole for wall mounting. You need to set two screws into the wall at the appropriate distance so that youcan hang the speaker from both mount holes. Proceed as follows.1 Screw two screws into the walls 300 mm (11-13/16 inches) apart, making sure that screws are horizontally level.Screw each screw only part way in, so that the screw projects 9 to 11 mm (3/8 to 7/16 inches) outward from the wallsurface.2 Hang the speaker by fitting the two mount holes (at the rear of the speaker) over the extending part of the screw.Confirm that the speaker is held firmly and securely in place.PrecautionsPlease observe the following precautions when mounting speaker onto the wall.• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. 3.0 kg [6.6 lb] ).• Wall screws must be purchased separately.• Be sure to use screws that are appropriate for the wall you are using, and that are long enough to provide sufficientstrength.• If you are uncertain about the wall’s support strength, the type of screw to use, or any other points regarding thistype of installation, please consult a contractor or other qualified person before proceeding.Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injuryor damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficientsupport strength.On Floor or ShelfPlace the speaker on the floor or on a shelf or other horizontalstable surface. Keep in mind that speaker is not fixed into place,so be careful to avoid knocking it over.• Attach four cushions to the baseof the speaker, one at each corner.The cushions prevent the speakerfrom sliding, and dampen its vibra-tions.• Attach each couple of provided cushions to make two setsof two-cushion piles, and attach them to the two positionsshown on the rear of the speaker. These piles will protectthe speaker body from damage and prevent the vibrationsof the speaker body from being transmitted to the wall.Installation Methods9 - 11 mm(3/8 to 7/16”)300 mm(11-13/16”)CushionMount holeCushion• Wall screws must be purchased separately.