PRK SWREVERSE58CONNECTION/INSTALLATIONCONNECTION/INSTALLATIONConnectionR Connecting wires to terminalsPages 59 – 60 Page 61USB terminal (0.8 m):Pages 59 – 60Connect the aerial cordto the aerial terminal.10 A fuseConnect to the vehicle’s reverse lamp harness whenusing the optional rear view camera.Connect to the vehicle’s parkingbrake detection switch harness.• For best safety, be sure toconnect the parking sensor.To the power control terminal when using the optional power amplifier or tothe aerial control terminal in the vehicle.To the terminal that is grounded when either the telephone rings or duringconversation. (To connect the Kenwood navigation system, consult yournavigation manual.)To use the steering wheel remote control feature, you need an exclusiveremote adapter (not supplied) matching your car is required.To car light control switchPurple with white stripe(Reverse sensor wire)Light green(Parking sensor wire) 31Blue with white stripe (Power control/aerial control wire)Brown (Mute control wire)Light blue with yellow stripe (Steering remote control wire)Orange with white stripe (Dimmer control wire)* 1 Only for DDX7015BT/DDX5015BT/DDX5015DAB.* 2 If no connections are made, do not let the cable comeout from the tab.Connector AConnector BPin Color and functions of Connector A and BA4 Yellow BatteryA5 Blue/White Power controlA6 Orange/White DimmerA7 Red Ignition (ACC)A8 Black Ground connectionB1/B2 Purple ª / Purple/Black · Right speaker (rear)B3/B4 Gray ª / Gray/Black · Right speaker (front)B5/B6 White ª / White/Black · Left speaker (front)B7/B8 Green ª / Green/Black · Left speaker (rear)Red(Ignition wire)UnitYellow(Battery wire)VehicleRed (A7)Yellow (A4)Default wiringConnecting the ISO connectors on some VW/Audi or Opel (Vauxhall) automobilesYou may need to modify the wiring of thesupplied wiring harness as illustrated below.*2Yellow (Battery wire)Red (Ignition wire)Red (A7)Yellow (A4)Pages 59 – 60Connect a commercial adapter. See page 60.*1