25DDX7032/7032M/712DNX7120/7220/7320This Test mode is applicable to models that are listed inTable 1.Class Series Model Name DestinationMIDDNX DNX8120 KDNX8220BT EDDXDDX812 KDDX8022BT EDDX8022BTY E2DDX8032BT M/X/RLOWDNXDNX7120 KDNX7220 EDNX7320CN VDDX DDX712 KDDX7032 M/X/V/RTable 1 List of Model Names1. OverviewThe succeeding sections describe the display specifica-tions, control specification of key/remote controller, opera-tions of components, etc. in the Test mode of this unit.2. OperationsThe system can be transferred to the Test mode with thefollowing two approaches:q While pressing [SRC] and [ATT] keys at the same time(SRC+ATT), press [Reset] key to start the system.w In the standby source, enter “2 → → 3” from the re-mote controller (SW: AUD).Turn the system OFF in 30 minutes when it is started in theTest mode.3. Screen transitionThe system is started with the Test Mode Main screen whenit is started in the Test mode. When the system is trans-ferred to the Test mode using the remote controller, it trans-fers to the Test Mode Main screen.A variety of screens that can be transferred from the TestMode Main screen is shown in Figure 2.Refer to Section 3 for the functions in each screen.4. Specification of screensThis section describes the Test mode functions available ineach screen.4.1. Test Mode Main screenThis section describes the keys that can be used to transferto each screen.Contents of the display shown in the Test Mode Mainscreen are described in Figure 4.1.Test Mode MainInformation Touch Auto AdjustService HPOSI InverterBluetoothDirect SelectExt SWiPodParrotTilt MechaFigure 4.1 Test Mode Main screenTest Mode MainInformation Service Direct Select Touch HPOSI iPod Auto Adjust Inverter Bluetooth ParrotInverterHigh/LowAuto AdjustStartiPodCheckGraphicTouch AdjustSourceAudioSetupE2PROMWrite NAVIE2PROMWriteSerial/TuneretcE2PROMWriteE2PROMWriteTilt MechaMechaAdjust ParrotCheckE2PROMWriteFigure 2 Screen transitionTEST MODE