Kenwood DDX8027 Installation Manual

Also see for DDX6027: Instruction manual Installation manual Service manual

Contents

Kenwood DDX8027 Installation Manual Manual pdf 10 page image

10 | EnglishRemoving Monitor Unit■ Removing the Hard Rubber Frame (escutcheon)1. Engage the catch pins on the removal tool 3and remove the two locks on the lower level.Lower the frame and pull it forward as shownin the figure.2. When the lower level is removed, remove theupper two locations.■ Removing the Unit1. Remove the hard rubber frame by referringto the removal procedure in the section.2. Remove the Hex-head screw with integralwasher (M4 × 8) on the back panel.3. Insert the two removal tools 3 deeply intothe slots on each side, as shown.4. Lower the removal tool toward the bottom,and pull out the unit halfway while pressingtowards the inside.5. Pull the unit all the way out with your hands,being careful not to drop it.Be careful to avoid injury from the catch pins onthe removal tool.The frame can be removed from the top side inthe same manner.Removal Tool (Accessory 3)LockCatchRemoval Tool(Accessory 3)

/ 12

Related manuals for Kenwood DDX6027