Kenwood DMX1057XR Quick Start Manual

Also see for DMX1057XR: Instruction manual

Connection/Installation28Ñ Microphone unit1) Check the installation position of themicrophone (accessory 3).2) Clean the installation surface.3) Remove the separator of the microphone(accessory 3), and stick the microphone tothe place shown below.4) Wire the microphone cable up to the unitwith it secured at several positions using tapeor other desired method.5) Adjust the direction of the microphone(accessory 3) to the driver.3Fix a cable with a commercial item of tape.Ñ Installing the main unitNOTE• Determine the slider position before installing themain unit. (P.26) The slider position cannot bechanged after installing to the vehicle.• Make sure that the unit is installed securely inplace. If the unit is unstable, it may malfunction(eg, the sound may skip).1 Remove parts that interfere withinstalling such as a panel on the vehicle.2 Install the car bracket to the main unit.Car bracket4 or 5Main unit3 Connect the wiring harness wires andperipheral equipment.4 Install the main unit to the vehicle.5 Reinstall the removed parts such as apanel on the vehicle.Panel on thevehicleMain unit