136Return to the Top pageControlling AudioCrossover network setupYou can set a crossover frequency ofspeakers.1 Touch the speaker to set the crossoverin the Speaker Select screen.2 Touch [X’over].X’over screen appears.3 Set each item as follows.TW (Tweeter) Gain *1(DNN9250DAB/ DNR8025BT)Adjust the tweeter level. (When front isselected on Speaker Select screen)GainAdjust the front speaker, rear speaker, orsubwoofer level.Phase *2Set the phase of subwoofer output.The phase is reversed 180 degrees when setto “Reverse”. (When subwoofer is selected onSpeaker Select screen)HPF FREQHigh Pass Filter adjustment. (When front or rearspeaker is selected on Speaker Select screen)LPF FREQLow Pass Filter adjustment. (When subwooferis selected on Speaker Select screen)Slope *3Set a crossover slope.*1 Only when “Tweeter” is set to “Small”,“Middle”, “Large” in .*2 Only when “Subwoofer” is set to a modeother than “None” in .*3 Only when “LPF FREQ”/“HPF FREQ” is set toa mode other than “Through” in .ÑCar type setupYou can setup the car type and speakernetwork, etc.1 Touch [Car Type] in the Audio SETUPscreen.Car Type screen appears.2 Select your car type from the list.NOTE• If your car type is selected, the Delay TimeAlignment is set automatically (for timingadjustment of sound output for each channel) tohave the highest surround effects.Speaker location setup1 In the Car Type screen, touch [Location].Speaker Location screen appears.2 Select the speaker locations using [D].Front SpeakerSelect the location from “Door”/ “On Dash”/“Under Dash”.Rear SpeakerSelect the location from “Door”/ “Rear Deck”,“2nd Row”/ “3rd Row” (Minivan, Passenger Van).
