Kenwood DNX7160 Installation Manual

Also see for DNX7020EX: Instruction manual Instruction manual Instruction manual GPS Navigation instruction manual GPS Navigation instruction manual

Contents

4 DNX SERIESAPRK SWAConnectionIf you connect the ignition wire (red) and the battery wire (yellow)to the car chassis (ground), you may cause a short circuit, that inturn may start a fire. Always connect those wires to the powersource running through the fuse box.Antenna CordFM/AM antenna inputFor best safety, be sure to connect the parking sensor.Parking sensor wire (Light Green)Connect to the vehicle's parking brakedetection switch harness.Battery wire (Yellow)Ground wire (Black) -(To car chassis)Ignition wire (Red)To steering remoteIf no connections are made, do not let the cable come out from the tab.Connect to the terminal that is grounded when eitherthe telephone rings or during conversation.Depending on what antenna you are using,connect either to the control terminal of the motor antenna, or to thepower terminal for the booster amplifier of the film-type antenna.When using the optional power amplifier,connect to its power control terminal.To car light control switchConnect to vehicle's reverse lamp harness whenusing the optional rear view camera.Ignition keyswitchACCCar fuse box(Main fuse)BatteryCar fuse boxTo connect the Kenwood navigation system,consult your navigation manual.To use the steering wheel remote control feature, you need to anexclusive remote adapter (not supplied) matched to your car isrequired.⁄⁄⁄⁄¤