Kenwood DNX7250DAB Quick Start Manual

Also see for DNX4250BT: Instruction manual Firmware upgrade guide

Contents

English ñ 29Ñ Connecting wires to terminals1234567812345678P.CONT ANT.CONTMUTEREMOTE CONT REMOTE INPUTSTEERING WHEELFuse (10A) Fuse (10A)Accessory 1ABCA: Black (Ground wire)B: Yellow (Battery wire)C: Red (Ignition wire)ConnectorAConnectorB2 WARNING for Connecting the ISO ConnectorThe pin arrangement for the ISO connectors depends on the type of vehicle you drive. Make sure to make the properconnections to prevent damage to the unit. The default connection for the wiring harness is described in (1) below. Ifthe ISO connector pins are set as described in (2), make the connection as illustrated. Please be sure to reconnect thecable as shown (2) below to install this unit to the Volkswagen vehicles etc.(2)The red (A-7 pin) of the vehicle’s ISO connector isconnected to the constant power supply, and theyellow (A-4 pin) is linked to the ignition.(1): Default settingThe red (A-7 pin) of the vehicle’s ISO connector is linkedwith the ignition, and the yellow (A-4 pin) is connectedto the constant power supply.Red (Ignition cable)Unit VehicleYellow (Battery cable) Yellow (A-4 pin)Red (A-7 pin) Red (Ignition cable)Unit VehicleYellow (Battery cable) Yellow (A-4 pin)Red (A-7 pin)Connect either to the power control terminal when using the optionalpower amplifier, or to the power terminal for the booster amplifier ofthe film-type or short pole type antenna.If no connections are made, do not let thewire come out from the tab.Connect to the terminal that is grounded when either the telephonerings or during conversation.To use the steering wheel remote control feature, an exclusive remoteadapter (not supplied) that matches your car is required.Blue/White (Power control/Antenna control wire)Brown (Mute control wire)Light Blue/Yellow (Steering remotecontrol wire)DAB antenna CX-DAB1 (Optional accessory)(DNX7250DAB, DNX525DAB, DNX4250DAB only)Use of a CX-DAB1(optional accessory) as a DABantenna is recommended.When using a commercially available DABantenna, the diameter of the SMB connectormust be Φ6.5 mm or less.Φ 6.5 mm(maximum)