Kenwood DNX891HD Instruction Manual

Also see for DNX5710BT: Firmware upgrade guide Quick start guide Quick start guide Instruction manual

Contents

108108Return to the Top pageControlling AudioCrossover network setupYou can set a crossover frequency ofspeakers.1 Touch the speaker to set the crossoverin the Speaker Select screen.2 Touch [X’over].X’over screen appears.3 Set each item as follows.TW (Tweeter) Gain *1 (DNX891HD,DNX7710BT, DNX691HD only)Adjusts the tweeter level. (When front isselected on Speaker Select screen)Gain (DNX891HD, DNX7710BT,DNX691HD only)Adjusts the front speaker, rear speaker, orsubwoofer level.Phase*2Sets the phase of subwoofer output.The phase is reversed 180 degrees when setto “Reverse”. (When subwoofer is selected onSpeaker Select screen)HPF FREQHigh Pass Filter adjustment. (When front or rearspeaker is selected on Speaker Select screen)LPF FREQLow Pass Filter adjustment. (When subwooferis selected on Speaker Select screen)Slope*3Sets a crossover slope.*1 Only when “Tweeter” is set to “Small”,“Middle”, “Large” in .*2 Only when “Subwoofer” is set to a modeother than “None” in .*3 Only when “LPF FREQ”/“HPF FREQ” is set toa mode other than “Through” in .Car type setupYou can setup the car type and speakernetwork, etc.1 Touch [Car Type] in the Audio SETUPscreen.Car Type screen appears.2 Select your car type from the list.NOTE• If your car type is selected, the Delay TimeAlignment is set automatically (for timingadjustment of sound output for each channel) tohave the highest surround effects.