Kenwood DNX892 Quick Start Manual

Also see for DNX4150BT: Instruction manual Quick start guide Quick start guide Instruction manual Quick start guide

Contents

58DNX892/ DNX772BH/ DNX692/ DNX572BH:Ñ FCC WARNINGThis equipment may generate or use radiofrequency energy. Changes or modifications to thisequipment may cause harmful interference unlessthe modifications are expressly approved in theinstruction manual. The user could lose the authorityto operate this equipment if an unauthorized changeor modification is made.NOTEThis equipment has been tested and found to complywith the limits for a Class B digital device, pursuantto Part 15 of the FCC Rules. These limits are designedto provide reasonable protection against harmfulinterference in a residential installation.This equipment may cause harmful interference toradio communications, if it is not installed and usedin accordance with the instructions. However, thereis no guarantee that interference will not occur in aparticular installation. If this equipment does causeharmful interference to radio or television reception,which can be determined by turning the equipmentoff and on, the user is encouraged to try to correctthe interference by one or more of the followingmeasures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipmentand receiver.• Connect the equipment into an outlet on acircuit different from that to which the receiver isconnected.• Consult the dealer or an experienced radio/TVtechnician for help.#CAUTIONUse of controls or adjustments or performance ofprocedures other than those specified herein mayresult in hazardous radiation exposure.In compliance with Federal Regulations, followingare reproductions of labels on, or inside the productrelating to laser product safety.JVC KENWOOD Corporation2967-3, ISHIKAWA-MACHI,HACHIOJI-SHI, TOKYO, JAPANTHIS PRODUCT COMPLIES WITH DHHSRULES 21 CFR SUBCHAPTER J IN EFFECT ATDATE OF MANUFACTURE.Location: Top plateDNX892/ DNX772BH/ DNX692/ DNX572BH:Ñ IC (Industry Canada) NoticeThis device complies with Industry Canada licence-exempt RSS standard(s).Operation is subject to the following two conditions:(1)This device may not cause interference, and(2) this device must accept any interference, includinginterference that may cause undesired operation ofthe device.The term “IC: ” before the certification/ registrationnumber only signifies that the Industry Canadatechnical specification were met.#CAUTIONThis equipment complies with FCC/IC radiationexposure limits set forth for an uncontrolledenvironment and meets the FCC radio frequency (RF)Exposure Guidelines in Supplement C to OET65 andRSS-102 of the IC radio frequency (RF) Exposure rules.This equipment has very low levels of RF energy thatit deemed to comply without maximum permissiveexposure evaluation (MPE). But it is desirable that itshould be installed and operated keeping the radiatorat least 20cm or more away from person’s body(excluding extremities: hands, wrists, feet and ankles).Under Industry Canada regulations, this radiotransmitter may only operate using an antenna of atype and maximum (or lesser) gain approved for thetransmitter by Industry Canada. To reduce potentialradio interference to other users, the antenna typeand its gain should be so chosen that the equivalentisotropically radiated power (e.i.r.p.) is not more thanthat necessary for successful communication.DNX892/ DNX772BH/ DNX692/ DNX572BH:• Contains Transmitter ModuleFCC ID : YZP-RBFAC21XX• Contains Transmitter ModuleIC: 7414A-RBFAC21XX