DNX9140QUICK START GUIDEFOR ADVANCED VOICE CONTROLThank you for choosing Kenwood’s most advanced multimedia and navigation receiver, theDNX9140. This product allows voice control for both navigation, internal sources and con-nected sources. This guide will show you some of the more commonly used commands youwill be using on a regular basis. For more detailed information on voice commands pleaserefer to the Voice Command Table packaged with this product.GETTING STARTED1It is important to not only use the correct words for voice control but to speak them clearly ata time when there is minimal background noise. For best results have the microphone facingthe driver, operate with vehicle windows and sunroof closed and with only one person (driver)talking while the unit is receiving the commands.The Push to Talk (PTT) button — Pushing the PTT button will enter the user intovoice control mode as well as exit out of voice control mode.BLUETOOTH™ COMMANDSTUNER/SATELLITE RADIO COMMANDSOnce your phone has been paired and phonebook information is available on the unit you can access the information by saying“Handsfree”. The next selection would most likely be “Phonebook”, “Incoming Calls”, “Outgoing Calls” or “Missed Calls”and “Page Up” or “Page Down” commands. When searching through a phonebook use the alphabetical search for best results. “SearchK” would bring up all names that start with K. Make a selection through the “Line One”, “Line Two”, etc. commands. Once youhave confirmed the correct number has been selected say “Call Number” to initiate the call.To enter Tuner or Satellite source say either“Tuner”, “Sirius®” or “XM®”. “Seek Up”or “Seek Down” commands can be used tochange channels either up or down. “PresetOne”, “Preset Two”, etc. can be used to se-lect a stored preset. Satellite Radio allows“Category List” to select the music, talkor sports content to be listened to. “PageUp”, “Page Down” and “Line One”, “LineTwo”, etc. will be used to make selectionsduring this type of operation.20232022222321242421iPod®/iPhone® COMMANDSSaying “iPod“ will change the current source to iPod from any other source that may be currently selected. “Search Artist”, “SearchPlaylist”, and “Search Album” are good recommended starting points to begin selecting the music you would like to listen to.The recommended step would be to narrow the search through the alphabetical search function. “Search M” would list artists, albums,playlists or songs that begin with the letter M depending which category of search was selected. Use the “Page Up” or “Page Down”commands until the desired music is displayed on the screen then select the music by “Line One”, “Line Two” commands. If analbum is listed as a selection along with other albums and you would like to play the entire album then say“Play One”, “Play Two”, etc.161618181719191A Green Icon means ready to receive a voice command and aRed/Brown icon means the unit is not actively listening for avoice command. It is critical that a command is given only when theicon is green even if the confirming text may be seen on the screenbefore the icon turns green.2 34After entering the voice control mode foraudio sources such as iPod®, Tuner, Satelliteor DVD/CD small green dots will appear nextto the GUI buttons that can be controlled bya voice command.TOP RIGHT CORNER VOICE CONTROL ICONS23417® 2009 Kenwood USA Corporation. All Rights Reserved. iPod® and iPhone® are registered trademarks of Apple Computer, Inc. registered in the United Statesand other countries. The Bluetooth trademarks are owned by SIG, Inc. HD Radio™ are proprietary trademarks of iBiquity Digital Corp. Sirius and related marksare trademarks of Sirius Satellite Radio, Inc. All other brand, product names, or logos may be trademarks or registered trademarks of their respective holders.