Kenwood DP-SE9 Instruction Manual

Also see for R-SE9T: Instruction manual Service manual

Kenwood DP-SE9 Instruction Manual Manual pdf 12 page image

R-SE9T/DP-SE9/X-SE9 (En)12Preparation sectionBasic sectionApplication sectionKnowledge sectionsSystem connectionSYSTEMCONTROLANTENNAAMGNDCDINRECPLAYSUPERWOOFERPRE OUTSPEAKERS( 6 - 16 )RTAPETAPERECPLAYMDMDAUXFM75+-INLR R LLSPEAKERS( 6 - 16 )LRSUPERWOOFERPRE OUTSpeaker (right)(6-16Ω)Connect the speakers as shown in the figure.Do not plug the power cord into a wall AC outlet until the connection has been completed.3. Connection of speakers1 Cord preparation.2 Loosen.3 Insert.4 Secure.R-SE9T¶ Never short-circuit the + and – speaker cords.The protection circuit will operate and no sound willbe put out.¶ If the left and right speaker connections or the + and– polarity are inverted, the sound will be unnaturalwith unclear localization of musical instruments, etc.Be sure to connect them without mistake.Speaker (left)(6-16Ω)· ª ª ·Super woofer (SW-500) (optional)Extremely low frequency sound is played back powerfully.This can be used with any type of playback.1 Secure.2 Insert.• Sound will not be heard ifthe speaker terminal is notfully secured.Connection of banana plugs