Kenwood DPF-3030 Instruction Manual

22÷ Insert the power plug firmly to the AC outlet.÷ Turn the amplifier’s power ON.÷ Load the disc again with its label side up.÷ Insert the disc properly.÷ Wipe off the dust on the surface of the discreferring to “Disc handling precautions”. 9÷ Replace the disc with a new one.÷ Leave the player for about 1 hour so that thecondensation is removed. 9÷ Press the 6 key.÷ Wipe off the dust on the disc surface referringto “Disc handling precautions”. 9÷ Replace the disc with a new one.÷ Connect all connection cords firmly.÷ Adjust the output level with OUTPUT key onthe remote control unit. 7÷ Wipe off the dust on the disc surface referringto “Disc handling precautions”. 9÷ Replace the disc with a new one.÷ Try selecting a place where no strong vibra-tions occur by changing the installation place,etc.÷ If automatic play is not required, remove thedisc from the player before setting the unit toPOWER OFF.÷ Power plug is loosely connected.÷ With the power plug connected to the switchedAC outlet of an amplifier, the power of theamplifier is turned off.÷ Disc is loaded upside down.÷ Disc is loose.÷ Disc is dirty.÷ Disc is cracked.÷ Condensation has occurred on the optical lensunit.÷ Play mode is not entered.÷ Disc is too dirty.÷ Disc is cracked.÷ The connection cords are inserted loosely.÷ Output level is attenuated too low.÷ Disc is too dirty.÷ Disc is cracked.÷ Oscillation is applied to this unit.÷ This unit is designed so that play begins auto-matically when the unit is turned ON if a discis already loaded.The unit is not turned ON with thePOWER switch ON.Disc is loaded, player does not play.No sound.Music is interrupted. (Sound is skipped.)Play begins as soon as the unit is turnedON.Remote control operation is not possi-ble.÷ Batteries are exhausted.÷ The remote control unit is too far away fromthe main system, controlling angle is too large,or there is an obstacle in between.÷ Replace with new batteries. !÷ Operate the remote control unit within thecontrollable range. !In case of difficultyWhat appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult thetable below to see if the problem can be corrected before seeking help from your dealer or service representative.Operation to resetThe microcomputer may fall into malfunction (impossibil-ity to operate, erroneous display, etc.) when the connec-tion cords are unplugged while unit is ON or due to anexternal factor. In this case, execute the following methodto reset the microcomputer and return it to normal condi-tion.CD player unitRemote control unit÷ Please be aware that resetting the CD player will erase all storedinformation and return it to the factory settings.Set the unit to OFF by pressing the POWER switch, andafter a few seconds, turn the unit ON by pressing thePOWER switch again.Symptom Cause RemedySymptom Cause Remedy

/ 24

Related manuals for Kenwood DPF-3030