Kenwood DPX-4020 Instruction Manual

Also see for DPX-4020: Service manual Service manual

Kenwood DPX-4020 Instruction Manual Manual pdf 11 page image

— 11 —Press the SRC (source) button repeatedly to select the tunermode. "TUNER" is displayed when the tuner mode has beenselected.Press either the FM or AM button to select the band.Each time you press the FM button, the band switchesbetween the FM1, FM2 and FM3.Press the AM button to select the AM band.• Auto Seek TuningPress the ¢ button to seek higher frequencies.Press the 4 button to seek lower frequencies.• Preset station seek tuningPress the ¢ button to move to the next preset station (i.e.,the one with the next highest number), and the 4 button tomove to the last preset station (i.e., the one with the nextlowest number).If the frequencies stored at the preset numbers receivestations which were not originally memorized when travelinglong distances, the preset number is not displayed. In suchcases, pressing the 4/¢ button to use preset stationseek will receive channel 1.• Manual TuningPress the ¢ button to increase the frequency by one step.Press the 4 button to decrease the frequency by one step.• Please see the function set system about selecting tuningmode. (page 29)• The ST indicator lights up when stereo broadcasts are beingreceived.NOTENOTE321TuningWhen you know the frequency of the station that you want tolisten to, you can input it directly for quick access.Select the band by pressing the FM or AM button.1Direct Access Tuning (Function of remote)Press the DIRECT button."----" is displayed for 10 seconds.If you make no input in the 10-second period, direct accesstuning is automatically canceled.Enter the frequency of the desired station.If you want to listen to an FM station at 92.1 MHz, forexample, press 9, 2, and 1.If you want to listen to an AM station at 810 kHz, for example,press 8, 1, and 0.• You cannot enter frequencies above or below what a band canreceive.• FM frequencies can only be input in 0.1 MHz steps, and not0.01 MHz steps.Canceling Direct Access Tuning:Press the DIRECT button again.NOTE32Store the frequency of a station. You can then recall thatstation with a single touch of a button.Select the band/station that you want to have stored.Press the button (#1-6) that you want to use for the station, forat least two seconds.The button number blinks once in the display to indicate thatthe data has been stored.Recalling a Preset Station:Press the preset station button (#1-6) for the desired station.The number of the recalled station is displayed.You can store six stations in each of the FM1, FM2, FM3, andAM bands.NOTE21Station Preset Memory