Kenwood DPX405BT Quick Start Manual

Also see for DPX305U: Manual Service manual Manual Quick start guide

Contents

English | 3Before use2 WARNINGTo prevent injury or fire, take the followingprecautions:• Stop the car before operating the unit.• To prevent a short circuit, never put or leave anymetallic objects (such as coins or metal tools) insidethe unit.¤ CAUTION• Adjust the volume so that you can hear soundsoutside the car. Driving with the volume too highmay cause an accident.• Wipe off the dirt on the panel with a dry silicon orsoft cloth.Failure to observe this precaution may result indamage to the monitor or unit.”CondensationWhen the car is air-conditioned, moisture may collecton the laser lens. This may cause disc read errors. Inthis case, remove the disc and wait for the moisture toevaporate.Notes• If you experience problems during installation,consult your Kenwood dealer.• When you purchase optional accessories, check withyour Kenwood dealer to make sure that they workwith your model and in your area.• Characters that conform to ISO 8859-5 or ISO 8859-1can be displayed. Refer to “RUSSIAN SET” of <11-6.Initial settings>(Instruction Manual).• The Radio Data System feature won’t work where theservice is not supported by any broadcasting station.About discs used with this unit• This unit can only play the CDs with .• The following discs cannot be used:- Discs that are not round- Discs with coloring on the recording surface ordiscs that are dirty- Recordable/Rewritable disc that has not beenfinalized (For the finalization process, refer toyour disc writing software, and your disc recorderinstruction manual.)- 8 cm (3 inch) disc (Attempt to insert using anadapter can cause malfunction.)Handling discs• Do not touch the recording surface of the disc.• Do not stick tape etc. on the disc, or use a disc withtape stuck on it.• Do not use any accessories for the disc.• Do not use any solvents to clean discs. Use a drysilicon or soft cloth.• Clean from the center of the disc and move outward.• When removing discs from this unit, pull them outhorizontally.• Remove the rims from the center hole and disc edgebefore inserting a disc.How to reset your unitIf the unit fails to operate properly, press the Resetbutton. The unit returns to factory settings.Reset button