English | 9• After the installing the unit, check whether the brakelamps, blinkers, wipers, etc. on the car are workingproperly.• Mount the unit so that the mounting angle is 30°or less.• Reception may become poor if there are metalobjects near the Bluetooth antenna. (DPX405BT only)Bluetooth antenna unitFor Good ReceptionTo assure good reception, note the following:• Communicate with the cell-phone within the line-of-sight distance of 10 m (30 ft). The communicationrange becomes shorter depending on thesurrounding environment. The communicationrange also becomes shorter when there is anobstacle between this unit and the cell-phone. Theabove maximum communication range (10 m) is notalways assured.• A broadcast station or walkie-talkie located nearbycan interfere with communication due to a toostrong signal.! CAUTIONInstall this unit in the console of your vehicle.Do not touch the metal parts of this unit during andshortly after use of the unit. Metal parts such as theheat sink and enclosure become hot.Connecting Wires toTerminalsConnecting the ISO ConnectorThe pin arrangement for the ISO connectors dependson the type of the car. Make sure to make the properconnections to prevent damage to the unit.The default connection for the wiring harness isdescribed in 1 below. If the ISO connector pinsare set as described in 2, make the connection asillustrated.Please be sure to reconnect the cable as shown 2below to install this unit to the Volkswagen vehiclesetc.1 (Default setting) The A-7 pin (red) of the vehicle’sISO connector is linked with the ignition, and theA-4 pin (yellow) is connected to the constant powersupply.A-7 Pin(Red)A-4 Pin(Yellow)UnitVehicleIgnition cable(Red)Battery cable(Yellow)2 The A-7 pin (red) of the vehicle’s ISO connector isconnected to the constant power supply, and theA-4 pin (yellow) is linked to the ignition.A-7 Pin(Red)A-4 Pin(Yellow)UnitVehicleIgnition cable(Red)Battery cable(Yellow)