t out some sound‘q4$_:j_.f+ewPreparation) ONIOFFcE=‘5 ”l set the POWER switch to the ON (-1 positionBasic use methodmSelecting the desired inputVOLUME CONTROLL INPUTI IPOWER PHONESSwitching is done as follows when the INPUT key of themain unit is pressed. (The parenthesized part shows anoperating example.)@Tuner (frequency display)@ VCR (VCR --+ ANALOG + VCR)@ SAT/CABLE (SAT/CABLE 3 AUTO + SAT/CABLE)@ FRONT AUX (FRONT 3 OPTICAL 3 FRONT)0 DVDICDH Volume adjustmentTo increaseTo decreasel When one of the keys on the left IS pressed while STANDBYmode, the power will be switched on automatically and the inputWIII be selectedl The power WIII be switched on and the respective operation WIIIbe performed also when the OPEN/CLOSE key, the PLAY/PAUSE key or the BAND key on the maln unit IS pressed duringSTANDBY mode.l WhenadlscIssetlnthedlsctrayandtheDVDCDkeyIspressed,disc playback will start automaticallyThe present mode of the remote control unit may notl When using the remote to select SAT or CABLE,SAT (SAT 3 AUTO --f SAT)CABLE (CABLE 4 AUTO + CABLE)aThe input mode can be switched with SAT/CABLENote and FRONT AUX.Refer to “Changing the INPUT MODE” -I-$Normally “MAX” IS dlsplayed when the volume settings set tothe maximum valueIf you have adjusted the speaker level above Odb with theTRIM key (-Lx), “MAX” WIII not be dlsplayed.l Press the MUTE key.l Press agaln to resume the orIgInal volume.l The sound muting IS also canceiled when the volume IS con-trolled.Inset-t the headphone plug into the PHONES jack. This unit offers various surround modes, but It switchesautomatically to stereo mode when headphones are connected.To open the door, pull the lower part on the right side of themain unitl The sounds from all speakers are cut off.