Kenwood DVR-6300 Service Manual

Contents

CAUTION:Use of controls or adjustments or performance of proceduresother than those specified herein may result in hazardous radia-tion exposure.In compliance with Federal Regulations, the following are repro-ductions of labels on, or inside the product relating to laser prod-uct safety.KENWOOD CORPORATION2967-3, ISHIKAWA-CHO,HACHIOJI-SHI,TOKYO, JAPANKENWOOD CORP. CERTIFIES THIS EQUIPMENTCONFORMS TO DHHS REGULATIONS NO. 21 CFR1040.10, CHAPTER 1, SUBCHAPTER J.Location: Back PanelFor the U.S.A.For CanadaNOTICE: This Class B digital apparatus complies withCanadian ICES-003.Note to CATV system installerThis reminder is provided to call the CATV system installer’s at-tention to Article 820-40 of the NEC that provides guidelines forproper grounding and, in particular, specifies that the cableground shall be connected to the grounding system of the build-ing, as close to the point of cable entry as practical.For the U.S.A.Caution on condensationBefore transporting or moving this unit, carry out thefollowing operations.1. Set the POWER ON/OFF switch to the ONwithout loading a disc.2. Wait a few seconds and verify that the displayshown appears."NO DISC"3. Set the POWER ON/OFF switch to OFF.Note related to transportation and movementCondensation (of dew) may occur inside the unit when there is a greatdifference in temperature between this unit and the outside. This unitmay not function properly if condensation occurs. In this case, leavethe unit for a few hours and restart the operation after the condensa-tion has dried up.Be specially cautious against condensation in the following circum-stances:When this unit is carried from one place to another across a largedifference in temperature, when the humidity in the room wherethis unit is installed increases, etc.Operation to resetThe microprocessor may fall into malfunction(impossibility to operate erroneous display, etc.)when the power cord is unplugged while power isON or due to an external factor.In this case, switch off the power, wait for severalseconds, and then switch the power on again.The marking of products using lasers(For countries other than U.S.A. and Canada)The marking this product has been classified as Class 1. Itmeans that there is no danger of hazardous radiation outsidethe product.Location: Back panelCLASS 1LASER PRODUCTVideo cord (Yellow)(1)(E30-7341-08)Loop antenna (1)(T90-0917-08)FM indoor antenna (1)Remote control unit (1)(A70-1685-08)Batteries(R03/AAA) (2)Speaker cords (6) *(For Europe)(T90-0916-08)(For U.S.A., Canadaand Australia)(T90-0915-08)Accessories for speaker part(For DVT-6300 and DVT-7300)LengthFor Front (2) 4.5 m (177-3/16")For Center (1) 3 m (118-1/8")For Rear (2) 8 m (314-15/16")For Subwoofer (1) 4.5 m (177-3/16")Cushion (15) *(Small : 11 pcs 1 sheet) (Big : 4 pcs 1 sheet)* See speaker’s manual.DVR-63002CONTENTS / ACCESSORIES / CAUTIONSCONTENTS / ACCESSORIES / CAUTIONS...............2PARTS DESCRIPTIONS .............................................3PC BOARD ..................................................................4SCHEMATIC DIAGRAM ............................................15EXPLODED VIEW .....................................................25PARTS LIST...............................................................27SPECIFICATIONS .....................................................34CONTENTSACCESSORIESCAUTIONSSYSTEM CONFIGURATIONSSYSTEM RECEIVER SPEAKER SPEAKERDVT-6300-H DVR-6300 KSW-6300-H -DVT-6300-S DVR-6300 KSW-6300-S -DVT-7300 DVR-6300 KSW-7300 -DVT-8300 DVR-6300 KS-908HT SW-18HT