Reset button— 3 —Take the following precautions toprevent fire and avoid personal injury:• When extending the ignition wire, batterywire, or ground wire, use 0.75mm2 (AWG18)or larger automotive grade wire to avoid wiredeterioration or damage to the covering.• Check that no metal objects (coins, tools,etc.) are left inside the unit to avoid shortcircuits.• If you smell or see smoke, turn the poweroff immediately and consult your Kenwooddealer.• Do not touch the liquid crystal fluid if theLCD is damaged or broken due to shock. Theliquid crystal fluid may be dangerous to yourhealth or even fatal.If the liquid crystal fluid from the LCDcontacts your body or clothing, wash it offwith soap immediately.Take the following precautions tokeep the unit in proper working order.• Be sure the unit is connected to a 12V DCpower supply with a negative groundconnection.• Do not open the top or bottom cover.• Do not install the unit in places it is exposedto direct sunlight, high heat or humidity,water may splash over it, or dust exists.2CAUTION2WARNING IMPORTANT INFORMATIONAbout the disc changer to beconnected:To connect a disc changer having the "O-N"switch to this unit, set the "O-N" switch to "N".Note that none of the KDC-C100, KDC-C302,C205, C705, and non-Kenwood CD changerscan be connected.You can damage both your unit and the CDchanger if you connect them incorrectly.Precautions when connecting disc changersreleased in 1997 or earlier.The optional switching adapter KCA-S210A isnecessary to connect a disc changer that isnot equipped with the "O-N" switch exceptKDC-C100, KDC-C302, C205 and C705.Cleaning the UnitIf the front panel gets dirty, turn off thepower and wipe the panel with a dry siliconcloth or soft cloth.Do not use hard cloths or paint thinner,alcohol, or other volatile solvents. These maydamage external surfaces or removeindicator characters.2CAUTIONSafety Precautions• When replacing a fuse, only use a new onewith the prescribed rating. Using a fuse withthe wrong rating may cause your unit tomalfunction.• To prevent a short circuit when replacing afuse, first disconnect the wiring harness.• If you have difficulty in installing this unit inyour vehicle, contact your Kenwood dealer.• If it doesn’t seem to be working properly,first press the Reset button. If themalfunction persists, consult your Kenwooddealer.• Some car stereos cause the sound of thetuner to make for a moment when anengine is activated.• The reception of the tuner may be reduceda little if the KCA-R70FM is used.• If the sound is lower than the tuner sound,raise up the volume level of the CD/MDwith using the receiver.• Do not use your own screws. Use only thescrews provided. If you use the wrongscrews, you could damage the unit.NOTE