Kenwood FleetSync TK-7150 Specifications

Also see for TK-7150: Specifications Instruction manual Instruction manual Service manual

Contents

specifications

ADS#26608 Printed in USAJQA-QMA1205SpecificationsApplicable MIL-STD & IPModel TK-7150 TK-8150GENERALFrequency RangeType1: 136~174MHz 450~500MHzNumber of Channels (Zone)*Conventional CH: Max.128 (1 zone x 128ch ~ 128 zones x 1ch)Trunking ID: Max. 250/zone (max.32 zones)Channel SpacingWide: 25kHz, 30kHz 25kHzNarrow: 12.5kHz, 15kHz 12.5kHzOperating Voltage 13.6V DC±15%Current DrainStandby: 0.5A 0.5AReceive: 2.3A 2.3ATransmit: Less than 12A Less than 13ADuty Cycle Transmit: 20%Operating Temperature Range -22ºF ~ +140ºF (-30ºC ~ +60ºC)Frequency Stability ±0.00025%(-22ºF ~ +140ºF)Antenna Impedance 50 ΩDimensions (W x H x D) 7-1/12” x 2” x 7”(180mm x 50mm x 170mm)Weight (net) 5.9 lbs (2.7kg)FCC ID ALH32273110 ALH32283110Band Spread 38MHz 50MHzModel TK-7150 TK-8150RECEIVER (Measurements made per EIA/TIA-603)Sensitivity12dB SINAD: 0.35μV20dB Quieting: 0.45μVSelectivityWide: 84dB (±30kHz) 80dB (±25kHz)Narrow: 76dB (±15kHz), 73dB (±12.5kHz)76dB (±12.5kHz)IntermodulationWide: 77dB (±30, 60kHz) 79dB (±25, 50kHz)Narrow: 75dB (±15, 30kHz) 73dB (±12.5, 25kHz)Spurious Response 85dBAudio OutputExternal: 12W (@ 4 Ω 3% distortion)13W (@ 4 Ω 5% distortion)Internal: 3.2W (@ 16 Ω 3% distortion)3.5W (@ 16 Ω 5% distortion)TRANSMITTER (Measurements made per EIA/TIA-603)RF Output Power 50 to 15 watts 45 to 15 wattsHigh: 50 watts 45 wattsLow: 15 watts 15 wattsType of EmissionWide: 16K0F3E, 20K0F1DNarrow: 11K0F3E, 11K2F1DSpurious Response 75dBFM Hum & NoiseWide: 48dBNarrow: 42dBMicrophone Impedance 600 ΩAudio Distortion Less than 1% at 1000Hz■ KMC-9CDesktop Microphone■ KMC-27AMicrophone(noise-canceling)■ KMC-27BMicrophone■ KMC-28AKeypad Microphone(noise-canceling)■ KCT-18Ignition Sense Cable■ KCT-22Remote Control Cable8 feet17 feet25 feet■ KCT-23DC Power CableMedium PowerDash (10 feet)Medium Power Remote(Positive: 23 feet,Negative: 3.3 feet)■ KES-5External Speaker■ KLF-2Line Filter■ KPS-10ARegulated DCPower Supply■ KPS-15DC SwitchingPower Supply■ KRK-9Single Control HeadRemote KitOptionsAll accessories and options may not be available in all markets. Contact an authorizedKenwood dealer for details and complete list of all accessories and options.Standard MIL 810C MIL 810D MIL 810E MIL 810FMethods/Procedures Methods/Procedures Methods/Procedures Methods/ProceduresLow Pressure 500.1/Procedure I 500.2/Procedure I, II 500.3/Procedure I, II 500.4/Procedure I, IIHigh Temperature 501.1/Procedure I, II 501.2/Procedure I, II Cat. A1 501.3/Procedure I, II Cat. A1 501.4/Procedure I, IILow Temperature 502.1/Procedure I 502.2/Procedure I, II Cat. C1 502.3/Procedure I, II Cat. C1 502.4/Procedure I, IITemperature Shock 503.1/Procedure I 503.2/Procedure I Cat. A1, C1 503.3/Procedure I Cat. A1, C1 503.4/Procedure I, IISolar Radiation 505.1/Procedure I 505.2/Procedure I 505.3/Procedure I 505.4/Procedure IRain 506.1/Procedure II 506.2/Procedure II 506.3/Procedure II 506.4/Procedure IIIHumidity 507.1/Procedure II 507.2/Procedure II 507.3/Procedure II 507.4Salt Fog 509.1/Procedure I 509.2/Procedure I 509.3/Procedure I 509.4Dust 510.1/Procedure I 510.2/Procedure I 510.3/Procedure I 510.4/Procedure I, IIIVibration 514.2/Procedure VIII, X 514.3/Procedure I Cat. 8 514.4/Procedure I Cat. 8 514.5/Procedure I Cat. 20Shock 516.2/Procedure I, II, III, V 516.3/Procedure I, IV, V 516.4/Procedure I, IV, V 516.5/Procedure I, IV, VKenwood follows a policy of continuous advancement in development.For this reason specifications may be changed without notice.* During simultaneous operation of conventional and LTR® modes.Conventional channel/trunking ID can be programmed up to 512.footnotes from Front:1 KRK-9, KCT-22M/M2/M3, KCT-23M/M3remote control options required.2 6-Pin Accessory Connector for externalspeaker, PA Output & ignition sense input.3 KCT-18 ignition sense cable option required;plugs into mobile 6-pin jack ignition sense input.4 Built-in PA/HA outputs (no option boardrequired); Horn Alert operates for 2-Tone orDTMF selective call decode only.5 Short Text Messages are radio stored & LCDdisplayed; Long Text Messages require aKDS-100 and KCT-40.6 FleetSync® GPS features require an internalGPS board or externally wired GPS receiverwith NMEA TTL level serial data output tothe internal COM 1 or 2 set to "GPS".FleetSync ®is a trademark of Kenwood Corporation.LTR® is a registered trademark of Transcrypt International.

/ 2

Related manuals for Kenwood TK-7150