Safety precautionsI A CAUTION ITo prevent damage to the machine, take thefollowing precautions:Be sure the unit is connected to a 12V DC powersupply with a negative ground connection.Do not open the top or bottom covers of the unit.Do not install the unit in a spot exposed to directsunlight or excessive heat or humidity. Also avoidplaces with too much dust or the possibility of watersplashing.When replacing a fuse, only use a new one with theprescribed rating. Using a fuse with the wrong ratingmay cause your unit to malfunction.• To prevent a short circuit when replacing a fuse, firstdisconnect the wiring harness.FCC WARNINGThis equipment may generate or use radiofrequency energy. Changes or modifications to thisequipment may cause harmful interference unlessthe modifications are expressly approved in theinstruction manual. The user could lose the authorityto operate this equipment if an unauthorized changeor modification is made.FCC NOTEThis equipment has been tested and found tocomply with the limits for a Class B digital device,pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection againstharmful interference in a residential installation. Thisequipment may cause harmful interference to radiocommunications, if it is not installed and used inaccordance with the instructions. However, thereis no guarantee that interference will not occur in aparticular installation. If this equipment does causeharmful interference to radio or television reception,which can be determined by turning the equipmentoff and on, the user is encouraged to try to correctthe interference by one or more of the followingmeasures:Reorient or relocate the receiving antenna.Increase the separation between the equipmentand receiver.Connect the equipment into an outlet on acircuit different from that to which the receiver isconnected.Consult the dealer or an experienced radiorrVtechnician for help.INOTE IThis Class B digital apparatus complies with CanadianICE5-003.~:fuJIf you experience problems during installation,consult your Kenwood dealer.If the unit does not seem to be working right,consult your Kenwood dealer.2 EnglishCE Declaration of Conformity withregard to the EMC Directive2004/1 08/ECManufacturer:Kenwood Corporation2967-3 Ishikawa-machi, Hachioji-shi, Tokyo,192-8525 JapanEU Representative's:Kenwood Electronics Europe BVAmsterdamseweg 37, 1422 AC UITHOORN,The Netherlands