Connection " Commercially available partsPower control wireI ~WARNING ITo prevent fire caused by a short in the wiring,connect a fusible link or breaker nearby thebattery's positive terminal.~CAUTION• RCA cable or Speaker level input connection• RCA cable connectionsICENTER UNIT 11------------ ¢. • • •• • • • • :L_(~C:D~r~ec=e~iv~e~r, ~et~c:) __f;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;;~ •RCA cable" •••~Left input"• Speaker level input connectionsCable Color of the connector Genuine-accessory carstereo (No line outputcenter unit etc.)8White/BIack•/' ,Right input LINE OUT terminalOGraOWhite8Gra IBlackDILeniii Right• If sound is not output normally, immediately turnpower off and check connections.• Be sure to turn the power off before changing thesetting of any switch.• If the fuse blows, check wires for shorts, thenreplace the fuse with one of the same rating.• Check that no unconnected wires or connectorsare touching the car body. Do not removecaps from unconnected wires or connectors toprevent short circuits.• Connect the speaker wires to appropriate speakerconnectors separately. Sharing the negative wireof the speaker or grounding speaker wires to themetal body of the car can cause this unit to fail.NOTE• Do not connect cables and leads to both RCAcable input jacks and the speaker level inputterminals simultaneously, for this may causemalfunction or damage.Speaker level Input connections• The genuine-accessory car stereo shall have amaximum power output of no more than 40 W.· The power is turned on and off as the unitdetects input signal (Signal Sensing Turn-ON).There fore it is not necessary to connect thepower control wire. • Power wire and Speaker wire connection•., ,.",O~ F"'o,,-, (20 + 20):1(40+40)e~e~8~• Dual voice coil subwoofer~~e Subwoofer (L + R)o '~(~20)\l::::==",O e ,- (1 When two subwoofers areo'~": connected. (~40)Power control wire"(RCA cable connection),..---.:...;;--.,;,;;";".;..:.,;,,,.-...;;,;,;;,.;.....:...._--- ~ .Terminal coverBatterywire" ~Protective Fuse"Fuse40Ax 1LINE OUT terminal• The signal that's input from the line inputterminal is output.Speaker output terminals· As this unit accepts speakers with a minimumimpedance of 2 ohms, connect speakers with 2-ohms or higher impedance to these terminals.4 English