Kenwood KAC-X41 Instruction Manual

Contents

EnglishP.CON SPEAKER OUTPUTBRIDGEDLEFT RIGHTFUSE [30Ax2]GNDBATT.+LINE OUTLINE INLRA ASPEAKER OUTPUTBRIDGED B BA BSPEAKER OUTPUTBRIDGEDSPEAKER OUTPUTBRIDGEDLEFT RIGHTLEFT RIGHTA BLEFT RIGHTCAUTION• If sound is not output normally, immediatelyturn power off and check connections.• Be sure to turn the power off beforechanging the setting of any switch.• If the fuse blows, check wires for shorts, thenreplace the fuse with one of the same rating.• Check that no unconnected wires orconnectors are touching the car body. Donot remove caps from unconnected wires orconnectors to prevent short circuits.• Connect the speaker wires to appropriatespeaker connectors separately. Sharing thenegative wire of the speaker or groundingspeaker wires to the metal body of the carcan cause this unit to fail.• After installation, check that the brakelamps, winkers, and wipers work properly.* Commercially available partsWARNINGTo prevent fire caused by a short in thewiring, connect a fusible link or breakernearby the battery’s positive terminal.ConnectionGround wire*Power control wire*B channelRight speakerBattery wire*Protective Fuse*CENTER UNIT(CD receiver, etc.)RCA cable*Left inputRight inputBatteryBridged ConnectionsB channelLeft speakerA channelRight speakerA channelLeft speakerB channelSpeaker (Bridged)A channelSpeaker (Bridged)A channel inputB channel inputHexagon Wrench(Small)HexagonWrench (Large)Hexagon Wrench(Small)Use theattachedHexagonWrench.Use theattachedHexagonWrench.WARNINGRemove the ignition key anddisconnect the negative · terminal ofthe battery to prevent short circuits.Hexagon Wrench(Small)HexagonWrench(Large)Terminal coverNOTEUse a RCA cablewith a straightterminal. If a RCAcable with L typeterminal is used, itmay not be able toconnect.About the Lead Terminals1. Wire ThicknessesYou can use wires with the following thicknesses:Battery wire and ground wire AWG 4 – AWG 6Speaker wire AWG 8 – AWG 122. Strip the wireMake a cut in the wire sheath (insulator made from vinyl, etc.) at theposition 10-13 mm away from the end of the wire, and then remove theunnecessary portion of the sheath by twisting it.3. Install the wireLoosen the screw using the supplied hexagon wrench. Insert theconductor of the wire in the terminal hole, and then tighten the screw.10 - 13 mm(3/8" - 1/2")