Kenwood KCA-RC50MR Installation Instructions Manual
Also see for KCA-RC50MR - Marine Wired Remote Control: Training guide
 | |
Contents |
KCA-RC50MRMarine Remote ControlInstallation InstructionsMounting The Remote Control:1. Select a mounting location that is flat and 1/2” thick or less.2. Using the supplied rubber gasket as a template, drill the mounting holes and a hole for the wiringat the desired locations.3. Mount the remote control according to the diagram in FIG. 1 using supplied hardware.4. Connect the electrical wiring for power, illumination, and ground as shown in FIG. 1.Connect supplied data line to remote, route to the radio and connect to the connector on therear of the radio as shown in FIG. 2.Data Line ConnectionPoint:Note, The rear view of radio and locationof connection point will vary dependenton radio model.FIG. 22 AMP FUSERED + 12V switched/ignitionYELLOW Illumination (connect to instrument lighting)BLACK: groundBLUE Data line (connect to radio)FIG. 1NUTLOCK WASHERWASHERMOUNT ING SURFACEGASKETREMOT E |
Related manuals for Kenwood KCA-RC50MR - Marine Wired Remote Control
Kenwood KCA-RC60MR Instruction Manual
Kenwood KCA-RC55MR Instruction Manual
Kenwood KCA-RC55MR Instruction Manual
Kenwood KCA-RC527 Instruction Manual
Kenwood KCA-RC547 Instruction Manual
Kenwood KCA-RC527 Instruction Manual
Kenwood KCA-RC547 Instruction Manual
Kenwood KCA-RC35MR Instruction Manual
Kenwood KCA-RC35MR Instruction Manual
Kenwood KCA-RC107MR Instruction Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine