Kenwood KDC-115S Instruction Manual

Also see for KDC-115S: Service manual

Contents

Kenwood KDC-115S Instruction Manual Manual pdf 17 page image

— 17 —be a malfunction in your unit may just be the result of slight misoperation or miswiring., first check the following table for possible problems.uideSOLUTIONPOSSIBLE CAUSEOne of the speaker wires is being pinched by a screw inthe car.Check the speaker wiring.theThe fader or balance settings are set all the way to oneside.Reset the fader or balance settings.The input/output wires or wiring harness are connectedincorrectly.Reconnect the input/output wires or the wiring harnesscorrectly. See the section on "Connecting Wires toTerminals".The computer chip in the unit is not functioning normally. Press the reset button on the unit (see p. 4).rThe speakers are not wired correctly. Reconnect the speaker wires so that each outputterminal is connected to a different speaker.The antenna control wire is not connected. Connect the wire correctly, referring to the section on"Connecting Wires to Terminals".car antenna is not extended. Pull the antenna out all the way.. The fuse has blown. After checking for short circuits in the wires, replace thefuse with one with the same rating.Attenuator is turned on. Turn off Attenuator.The CD is upside-down. Load the CD with the labeled side up.n The battery wire has not been connected to the properterminal.The CD is quite dirty. Clean the CD, referring to the section on "Cleaning CDs"(see p. 5).e CD is scratched or dirty. Clean the CD, referring to the section on "Cleaning CDs"(see p. 5).play has been selected. Turn off random play.The ignition and battery wire are incorrectly connected.Connect the wire correctly, referring to the section on"Connecting Wires to Terminals".Connect the wire correctly, referring to the section on"Connecting Wires to Terminals".The mounting angle exceeds 30°. Adjust to an angle of less than 30°.PM Page 17