Kenwood KDC-200UB Instruction Manual

Also see for KDC-100UB: Instruction manual

Contents

Kenwood KDC-200UB Instruction Manual Manual pdf 8 page image

6Other settings1 Press the volume knob to enter [FUNCTION].2 Turn the volume knob to select an item (see the following table), thenpress the knob.3 Repeat step 2 until the desired item is selected or activated.4 Press and hold to exit.To return to the previous setting item, press .Default: XXTUNER SETTINGLOCAL SEEK ON: Searches only stations with good reception. ; OFF: Cancels.• Settings made are applicable only to the selected source/station. Once you changethe source/station, you need to make the settings again.AUTOMEMORYYES: Automatically starts memorizing 6 stations with good reception. ; NO: Cancels.• Selectable only if [NORMAL] is selected for [PRESET TYPE]. ( 5)MONO SET ON: Improves the FM reception, but the stereo effect may be lost. ; OFF: Cancels.NEWS SET ON: The unit will temporarily switch to News Programme if available. ; OFF: Cancels.REGIONAL ON: Switches to another station only in the specific region using the “AF” control. ;OFF: Cancels.AF SET ON: Automatically searches for another station broadcasting the same programin the same Radio Data System network with better reception when the currentreception is poor. ; OFF: Cancels.TI ON: Allows the unit to temporarily switch to Traffic Information if available (“TI”lights up). ; OFF: Cancels.PTY SEARCH 1 Press the volume knob to enter PTY language selection.2 Turn the volume knob to select the PTY language (ENGLISH/ FRENCH/GERMAN), then press the knob.3 Turn the volume knob to select the available Program Type (see the following).4 Press S / T to start searching.RADIOSearch for a station1 Press repeatedly to select TUNER.2 Press repeatedly (or press / onRC-406) to select FM1/ FM2/ FM3/ MW/ LW.3 Press S / T (or press S / on RC-406) to searchfor a station.• To change the searching method for S / T: Pressrepeatedly.AUTO1 : Automatically search for a station.AUTO2 : Search for a preset station.MANUAL : Manually search for a station.• To store a station: Press and hold one of the number buttons(1 to 6).• To select a stored station: Press one of the number buttons(1 to 6) (or press one of the number buttons (1 to 6) on RC-406).Direct Access Tuning (using RC-406) (for )1 Press DIRECT to enter Direct Access Tuning.2 Press the number buttons to enter a frequency.3 Press to search for a station.• To cancel, press or DIRECT.• If no operation is done for 10 seconds after step 2, Direct AccessTuning is automatically canceled.