Kenwood KDC-2027SA Instruction Manual

Also see for KDC-2027SA: Instruction manual Instruction manual

Contents

Kenwood KDC-2027SA Instruction Manual Manual pdf 13 page image

— 13 —The use of any accessories except for those provided might result indamage to the unit. Make sure only to use the accessories shipped withthe unit, as shown above...........................................1..........................................2..........................................1123External view Number of items1. To prevent short circuits, remove the key from the ignition anddisconnect the - terminal of the battery.2. Make the proper input and output wire connections for each unit.3. Connect the wire on the wiring harness.4. Take Connector B on the wiring harness and connect it to thespeaker connector in your vehicle.5. Take Connector A on the wiring harness and connect it to theexternal power connector on your vehicle.6. Connect the wiring harness connector to the unit.7. Install the unit in your car.8. Reconnect the - terminal of the battery.9. Press the reset button.• If your car is not prepared for this special connection-system,consult your Kenwood dealer.• Only use antenna conversion adapters (ISO-JASO) when theantenna cord has an ISO plug.• Make sure that all wire connections are securely made byinserting jacks until they lock completely.• If your vehicle's ignition does not have an ACC position, or if theignition wire is connected to a power source with constantvoltage such as a battery wire, the power will not be linked withthe ignition (i.e., it will not turn on and off along with theignition). If you want to link the unit's power with the ignition,connect the ignition wire to a power source that can be turnedon and off with the ignition key.• If the fuse blows, first make sure that the wires have not causeda short circuit, then replace the old fuse with one with the samerating.• Insulate unconnected wires with vinyl tape or other similarmaterial. To prevent short circuits, also do not remove the capson the ends of the unconnected wires or the terminals.• Connect the speaker wires correctly to the terminals to whichthey correspond. The unit may receive damage or fail to work ifyou share the - wires and/or ground them to any metal part inthe car.• After the unit is installed, check whether the brake lamps,indicators, wipers, etc. on the car are working properly.• If the console has a lid, make sure to install the unit so that thefaceplate does not hit the lid when closing and opening.• Mount the unit so that the mounting angle is 30° or less.2CAUTIONAccessoriesInstallation Procedure