Kenwood KDC-3020R Instruction Manual

Also see for KDC-3020R: Service manual

Contents

— 23 —■ Removing the hard rubber frame2 When the lower level is removed, remove the upper twolocations.The frame can be removed from the top side in the same manner.CatchLock1 Engage the catch pins on the removal tool and remove the twolocks on the lower level.Lower the frame and pull it forward as shown in the figure.Accessory2Removal tool8 mmMAX.ø5mm ø5mm8mmMAX.■ Installing in Japanese-Made CarsT: Toyota carsN: Nissan carsTNNT T/NAccessory4...for Nissan carAccessory5 ...for Toyota car• During installation, do not use any screws except for those provided.The use of different screws might result in damage to the main unit.• Damage may occur if a screwdriver or similar tool is used withexcessive force during the installations.1 Refer to the section "Removing the hard rubber frame" (page 23)and then remove the hard rubber frame.2 Align the holes in the unit (two locations on each side) with thevehicle mounting bracket and secure the unit with the accessoryscrews.4 5InstallationAccessory6■ Screwing the Faceplate on the UnitNever insert the taptite screw (ø4 × 16 mm) in any other screw holethan the one specified. If you screw it in another hole, it will contactand may cause damage to the mechanical parts inside the unit.If you want to fasten thefaceplate to the main unit sothat it does not fall off,screw in the provided screw(ø4 X 16 mm) in the holeshown below.