Kenwood KDC-400U Instruction Manual

Contents

Before reading this manual, click the button below to check the latest edition and themodified pages.IM360_Ref_K_en_01© 2012 JVC KENWOOD CorporationKDC-400UCD-RECEIVERINSTRUCTION MANUALTake the time to read through this instruction manual.Familiarity with installation and operation procedures will help you obtain the best performance from your newCD-receiver.For your recordsRecord the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the spaceprovided below. Refer to the model and serial numbers whenever you call upon your Kenwood dealer for information orservice on the product.Model KDC-400U Serial numberUS Residence OnlyRegister OnlineRegister your Kenwood product at www.Kenwoodusa.comAbout the notation “Contents ”Clicking “Contents” shown at the upper left of eachpage allows you to jump to the contents page.Function setting procedureFor the procedure for selecting a setting item in theFunction setting mode, see the following example:Example: Adjusting the contrast of the display1 Enter the Function setting modePress and hold the Control knob.“Function” is displayed.2 Select the Contrast function itemInitial SettingsTuner SettingsPlay ModeClock&DateDISP NEGA/POSIDisplay DimmerSettingsDISP&ILLUMIContrastTurn the Control knob to select “Settings”, andthen press the Control knob.Next, turn the Control knob to select“DISP&ILLUMI”, and then press the Controlknob.Finally, turn the Control knob to select“Contrast”, and then press the Control knob.In this manual, the above operationalprocedure is described as follows:2 Select the Contrast function itemSelect the following items using theControl knob.“Settings” > “DISP&ILLUMI” > “Contrast”Press the [ ] button to return to the previousitem.⁄• Clicking near the description of an operationalprocedure displays this page, allowing you to confirm howto use the Control knob.3 Set the Contrast functionTurn the Control knob to select a value (1 - 30),and then press the Control knob.The previous item is displayed.4 Exit the Function setting modePress and hold the [ ] button.How to read this manual