Kenwood KDC-BT61U Instruction Manual

Also see for KDC-6051U: Quick start guide

Contents

42 | KDC-BT61U/ KDC-6051UDSP SetupPress the [MENU] button for at least 1 second,and then press it again briefly.Audio Preset MemoryRegistering the value setup by Sound Control.1 Setup Sound ControlRefer to the following operations to setup theSound Control.- Car Type Selection (page 40)- Speaker Setting (page 40)- Car Type Fine Adjustments (page 41)- X’Over Setting (page 42)- Manual Equalizer Control (page 37)- Listening Position Selection (page 38)- Listening Position Fine Adjustments (page 38)2 Enter Audio preset memory modeTurn the [VOL] knob and press it when thedesired item is displayed.Select “Detailed Setup” > “Preset” > “Memory”.3 Select the number to put in the memoryTurn the [VOL] knob and press it when thedesired item is displayed.Select a preset number.4 Turn the [VOL] knob and press it when thedesired item is displayed.Select “YES”.“Memory Completed” is displayed.5 Exit Audio Control modePress the [MENU] button for at least 1 second,and then press it again briefly.⁄• Register 6 patterns of Audio Preset Memory.• Preset number “1”:When you press the Reset, all the sources will be thesetting value which is registered.• Preset number “1” and “2”:The memory cannot be erased by the Reset button.• This function cannot be registered when the iPodEqualizer set in (page 37).X’Over SettingFine adjusting the following setting valuescorresponding to the X’Over values set in thesection (page 40).Display Item Range“X’Over”“Front” “FC” Front High Pass FilterThrough, 30, 40, 50, 60, 70, 80, 90,100, 120, 150, 180, 220, 250 (Hz)“SLOPE” Front High Pass Slope-6, -12, -18, -24 dB/Oct“Rear” “FC” Rear High Pass FilterThrough, 30, 40, 50, 60, 70, 80, 90,100, 120, 150, 180, 220, 250 (Hz)“SLOPE” Rear High Pass Slope-6, -12, -18, -24 dB/Oct“SubWoofer” “FC” Subwoofer Low Pass Filter30, 40, 50, 60, 70, 80, 90, 100, 120,150, 180, 220, 250*, Through (Hz)“SLOPE” Subwoofer Slope-6, -12, -18, -24 dB/Oct“PHASE” Subwoofer PhaseReverse (180°)/ Normal (0°)( : Factory setting)1 Select the sourcePress the [SRC] button. Turn the [VOL] knob andpress it when the desired item is displayed.Select a source other than “STANDBY”.✍ SRC Select mode 2: Pressing the [SRC] buttonrepeatedly switches source.2 Enter Audio Control modePress the [VOL] knob.3 Enter X’Over setting modeTurn the [VOL] knob and press it when thedesired item is displayed.Select “Detailed Setup” > “X’Over”.4 Select the speaker you want to setTurn the [VOL] knob and press it when thedesired item is displayed.Select “Front”, “Rear”, or “SubWoofer”.5 Select the item you want to setOperation type OperationSelects the item. Turn the [VOL] knob.Adjust each item. Press the [4] or [¢] button.Set the value Press the [VOL] button.6 Repeat steps 3 to 4 to complete the X’Oversettings.7 Exit Audio Control mode