Kenwood KDC-BT740DAB Instruction Manual

Also see for KDC-BT740DAB: Quick start guide

ENGLISH 37Installation/Connection7 Remove the film covering the earth sheet and paste the earth sheet on the metal partof the vehicle.Provide sufficient leeway for the earth sheet so that it does not interfere with the interior parts(front pillar cover). Also take care that the interior parts do not interfere with the amplifier unit(G).(G)WindscreenEarth sheetFront pillar cover8 Wire the antenna cables.Use cable clamper (H) to secure the antenna to the pillar at several positions.9 Attach the front pillar cover back to its original position.Be sure not to damage the earth sheet and amplifier unit (G) when covering.10 Connect the amplifier unit (G) to the DAB antenna jack on the rear of the unit.Note:Make sure [DAB ANT POWER] is set to [ON] on the [FUNCTION] menu in standbymode. (Page 6)[ON] is selected initially.ReferencesMaintenanceCleaning the unitWipe off dirt on the faceplate with a dry silicone or soft cloth.Cleaning the connectorDetach the faceplate and clean the connector gentlywith a cotton swab. Be careful not to damage theconnector.Handling discs• Do not touch the recording surface of the disc.• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.• Do not use any accessories for the disc.• Clean from the center of the disc and move outward.• Clean the disc with a dry silicone or soft cloth. Do not use any solvents.• When removing a disc from this unit, pull it out horizontally.• Remove burrs from the center hole and disc edge before inserting a disc.More informationFor: – Latest firmware updates and latest compatible item list– KENWOOD original application– Any other latest informationVisit .General• This unit can only play the following CDs:• For detailed information and notes about the playable audio files, visit.Connector (on the reverseside of the faceplate)