Kenwood KDC-C469FM Instruction Manual

Also see for KDC-C469FM: Service manual

Kenwood KDC-C469FM Instruction Manual Manual pdf 15 page image

— 15 —Installation ProcedureAngle adjustment switches■The angle adjustment switches on the both saides of the unitare to be set according to the angle of installation of the CDauto changer. Set both of the two switches to the sameposition. If the switches are not set properly, sound skip orother malfunction may occur.Set the angle adjustment switches with a coin or other flatobject.Change the switch step by step by detaching and reusing theobject at the end of each step.Right side Left sideAngle adjustment switches9090045900 45Installationangle0°~5° 40°~50° 85°~90°900459004590045Angleadjustmentswitchposition• It is not possible to install at an angle of40°~50° if only 1 is used.InstallationInstallation of Display unit■• Installation without using the trim mount plate 7Attach one velcro to theslanted-line of the the displayunits as shown above, andattach the other velcro to theparts where you wish toattach the display units.Then, put velcros togetherand install the display units.• Installation using the trim mount plate 7C D A U T O C H A N G E R C O N T R O L L E RREPRDM31 ¡PWR'R D M R E PM H zT R A C KD I S C 8/T R A C KFREQLEVEL-+DISCDisplay unitDisplay unit57Pass the wire from the display unit through the hole on thetrim mount plate and push fit the display unit into the trimmount plate until it locks.• Be sure not to place the unit on such place as where it isexposed to direct sunlight and temperature eventually rises.It results in the deformation of the case.• Depending on the installing location, the display unit may notbe able to receive the signals from the controller unit. Installthem after confirming that the signals can be received.• Install the unit in such a way that it does not disturb driving.2CAUTION