Kenwood KDC-CMP59FM Instruction Manual

Also see for KDC-CMP59FM: Service manual Instruction manual Instruction manual

Contents

Kenwood KDC-CMP59FM Instruction Manual Manual pdf 16 page image

— 16 —EnglishAccessories1 23 4External viewThe use of any accessories except for those provided might resultin damage to the unit. Make sure only to use the accessoriesshipped with the unit, as shown above.2CAUTIONWhen drilling a hole in the car chassis to install the unit, checkfirst that nothing is on the other side.• If the fuse blows, first make sure the wires aren’t touching tocause a short circuit, then replace the old fuse with one with thesame rating.• Do not let unconnected wires or terminals touch metal on the caror anything else conducting electricity. To prevent a short circuit,do not remove the caps on the ends of the unconnected wires orthe terminals.• After the unit is installed, check whether the brake lamps,blinkers, wipers, etc. on the car are working properly.• Insulate unconnected wires with vinyl tape or other similarmaterial.• Some disc changers need conversion cords for connection. Seethe section on "Safety Precautions" for details.2CAUTION2WARNINGRemoving the transportation screws■TransportationscrewsRemove all 3 transportation screws for protecting the internalmechanism before you start to install the unit.After removing the transport screw, retain it carefully andattach it again before transporting the unit again.NOTE1. To prevent a short circuit, remove the key from the ignition anddisconnect the - battery.2. Make the proper input and output wire connections for each unit.3. Connect the wiring harness wires in the following order: ground,battery, ignition.4. Install the unit in your car.5. Reconnect the - battery.6. Press the reset button.Installation Procedure5 67 89Europe sales area only.