Kenwood KDC-HD552U Instruction Manual

Contents

Kenwood KDC-HD552U Instruction Manual Manual pdf 7 page image

7ENGLISHGetting startedCanceling the display demonstrationThe display demonstration is always turned on unless you cancel it.When you turn on the power (or after you reset the unit), the display shows:[CANCEL DEMO] \ [PRESS] \ [VOLUME KNOB]1 Press the volume knob.[YES] is selected as the initial setup.2 Press the volume knob again to confirm.[DEMO OFF] appears.If no operation is done for about 15 seconds or if you turn the volume knob to select [NO] instep 2, [DEMO MODE] appears and the display demonstration starts.Setting the demonstration mode1 Press the volume knob to enter [FUNCTION].2 Turn the volume knob to select [DEMO MODE], then press to enter.3 Turn the volume knob to select [ON] or [OFF].If [ON] is selected, display demonstration starts if no operation is done for about20 seconds.4 Hold to finish the procedure.Adjusting the clock1 Press the volume knob to enter [FUNCTION] mode.2 Turn the volume knob to select [SETTINGS], then press to enter.3 Turn the volume knob to select [CLOCK], then press to enter.4 Press the volume knob to select [CLOCK ADJUST].Clock hour flashes on the display.5 Turn the volume knob to adjust the hour, then press to enter minute adjustment.Clock minutes flashes on the display.6 Turn the volume knob to adjust the minute, then press to confirm.Press 4 / ¢ to move between the hour and minute adjustment.7 Hold to finish the procedure.Initial settings before operations1 Press SRC to enter [STANDBY] mode.2 Press the volume knob to enter [FUNCTION] mode.3 Turn the volume knob to select [INITIAL SET], then press to enter.4 Turn the volume knob to make a selection, then press to confirm.See table on page 8 for selection.5 Hold to finish the procedure.Continued...