Kenwood KDC-MP2035 Instruction Manual

Also see for KDC-MP2035: Instruction manual

Kenwood KDC-MP2035 Instruction Manual Manual pdf 8 page image

8 | EnglishGeneral featuresAudio Control1 Select the source to adjustPress the [SRC] button.2 Enter Audio Control modePress the [VOL] knob.3 Select the Audio item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Adjust the Audio itemTurn the [VOL] knob.Adjustment Item Display RangeSubwoofer level * "SW L" –15 — +15System Q "NATURAL"/"ROCK"/"POPS"/"EASY"/"TOP40"/"JAZZ"Natural/Rock/Pops/Easy/Top 40/JazzBass level "BAS L" –8 — +8Middle level "MID L" –8 — +8Treble level "TRE L" –8 — +8Balance "BAL" Left 15 — Right 15Fader "FAD" Rear 15 — Front 15Exit Audio Control mode (Volume control mode)⁄ About System Q• You can recall the best sound setting preset for differenttypes of music.• Change each setting value with the (page 8). First, select the speaker type with the Speakersetting.• "USER": This appears when Bass level, Middle level,and Treble level are adjusted. When "USER" isselected, these levels are recalled.• *Function of KDC-MP2035/KDC-MP235/KDC-MP2055 Exit Audio Control modePress any button.Press a button other than the [VOL] knob and [ATT]button.Audio SetupSetting the Sound system, such as Volume offset.1 Select the source to adjustPress the [SRC] button.2 Enter Audio Setup modePress the [VOL] knob for at least 1 second.3 Select the Audio Setup item to adjustPress the [VOL] knob.Each time you press the knob, the item to beadjusted alternates between the items shown inthe table below.4 Adjust the Audio setup itemTurn the [VOL] knob.Adjustment Item Display RangeLow Pass Filter* "LPF" 80/120/160/Through HzVolume offset "V-OFF" –8 — ±0 (AUX : –8 — +8)⁄• Volume offset: Sets each source’s volume as a differencefrom the basic volume.• *Function of KDC-MP2035/KDC-MP235/KDC-MP2055 Exit Audio Setup modePress the [VOL] knob for at least 1 second.Bass BoostBass sound can be enhanced by one-touchoperation.Press the [B.BOOST] button.When you press the button once, the current BassBoost setting is displayed.Each time you press the button, the Bass Boostsetting alternates.Setting DisplayBass Boost 1 "BB-L L1"Bass Boost 2 "BB-L L2"Bass Boost off "BB-L OFF"Speaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type.1 Enter StandbyPress the [SRC] button.Select the "STANDBY" display.2 Enter Speaker Setting modePress the [VOL] knob.