Kenwood KDC-MP238 Instruction Manual

Also see for KDC-138: Training guide Instruction manual Instruction manual Instruction manual Service manual

Contents

Kenwood KDC-MP238 Instruction Manual Manual pdf 6 page image

General OperationAudio Control G~1 Select the source to adjustPress the [SRC) button.2 Enter Audio Control modePress the [VOll knob.3 Select the Audio item to adjustPress the [VOL] knob.• Volume offset: Sets each source's volume as a differencefrom the basic volume.4 Adjust the Audio setup itemTurn the [VOL] knob.S Exit Audio Setup modePress the [VOL] knob for at least 1 second.Subwoofer level* "SW l"I"L SUB" -15 - + 15System Q "NATURAL/FLAT" / Natural/Rock/Pops/Easy/"ROCK" I"POPS" / Top 40/Jazz/User setting"EASY" I"TOP401TP40" /"JAZZ" I"USER"Speaker SettingFine-tuning so that the System Q value is optimalwhen setting the speaker type.1 Enter StandbyPress the [SRC] button.Select the "STANDBY"/ "STBy" display.2 Enter Speaker Setting modePress the [VOL] knob.3 Select the Speaker typeTurn the [VOL] knob.Bass level "BAS l" I"L BAS" -8 - +8Middle level "MID I" I"L MID" -8 - +8Treble level "TRE l" I"LTRE" -8 - +8Balance "BAl''I''Bl'' Left 15 - Right 15Fader "FAD" I"FD" Rear 15 - Front 15Exit Audio Control mode (Volume control mode)'Function of KDC-MP238/MP238CR/MP208/138G~• "USER": This appears when Bass level, Middle level, andTreble level are adjusted. When "USER" is selected,these levels are recalled.OFFFor 5&4 in. speaker"SP OFF" I"SP-F""SP 5/4"/"SP-5"4 Exit Speaker Setting modePress the [VOL] knob.4 Adjust the Audio itemTurn the [VOll knob.S Exit Audio Control modePress any button.Press a button other than the [VOL] knob.For 6& 6x9 in. speakerFor the OEM speaker"SP 6*9/6" /"SP-6""SP OEM" / "SP-O"Audio SetupFunction of KDC-MP23B/KDC-MP23BCR/KDC-MP20BSwitching DisplaySetting the Sound system.1 Select the source to adjustPress the [SRCl button.2 Enter Audio Setup modePress the [VOll knob for at least 1 second.3 Select the Audio Setup item to adjustPress the [VOL] knob.Changing the information displayed.1 Enter Switching Display modePress the center of the Control knob for at least1 second."DISP SEL" is displayed.2 Select the Display itemPress the right or left side of the Control knob.In Tuner source"FREQ"Frequency"V-OFF"I"V-OF" -8 - +0 (AUX -8 - +8)"LPF" 80/120/160/Through(OFF) HzVolume offsetLow Pass Fi Iter*'Function of KDC -MP238/MP238CR/MP208/138. Clock "CLOCK"6 I KDC-MP238/CR/KDC-MP208/KDC-138/CR