Kenwood KDC-MP338 Instruction Manual

Also see for KDC MP338 - Radio / CD: Training guide Instruction manual Instruction manual

Kenwood KDC-MP338 Instruction Manual Manual pdf 21 page image

English | 21Troubleshooting GuideSome functions of this unit may be disabled bysome settings made on this unit.! • Cannot set up the subwoofer.• Cannot set up the High Pass Filter.• Cannot set up the Fader.• No Audio control effect on AUX.▲ • Preout is not set to subwoofer. ☞ “SWPRE” of (page 12)• “Subwoofer output” of (page 4)is not set to On.• The Dual zone system function is enabled. ☞

! Cannot set up the subwoofer phase.▲ The Low Pass Filter is set to Through. ☞ Setup> (page 7)! • Cannot select the output destination of thesubsource in the Dual zone.• Cannot adjust the volume of the rear speakers.▲ The Dual zone function is disabled. ☞ Setup> (page 7)! • Cannot register a security code.• Cannot set up Display Illumination Control.▲ (page 14) is notturned off.What might seem to be a malfunction in your unitmay just be the result of slight misoperation ormiswiring. Before calling service, first check thefollowing table for possible problems.Tuner source? Radio reception is poor.✔ The car antenna is not extended.☞ Pull the antenna out all the way.Disc source? The specified disc does not play, but another oneplays instead.✔ The specified CD is quite dirty.☞ Clean the CD.✔ The disc is loaded in a different slot from thatspecified.☞ Eject the disc magazine and check the numberfor the specified disc.✔ The disc is severely scratched.☞ Try another disc instead.Audio file source? The sound skips when an Audio file is beingplayed.✔ The media is scratched or dirty.☞ Clean the media, referring to the CD cleaning ofthe section on (page 3).✔ The recording condition is bad.☞ Record the media again or use another media.