Kenwood KDC-MP436U Instruction Manual

Also see for KDC-MP436U: Firmware update guide

Kenwood KDC-MP436U Instruction Manual Manual pdf 29 page image

English | 29Removing the hard rubber frame1 Engage the catch pins on the removal tool andremove the two locks on the upper level.Upper the frame and pull it forward as shown inthe figure.CatchLockAccessory2Removal tool2 When the upper level is removed, remove thelower two locations.⁄• The frame can be removed from the bottom side in thesame manner.Removing the Unit1 Refer to the section frame> and then remove the hard rubber frame.2 Remove the screw (M4 × 8) on the back panel.3 Insert the two removal tools deeply into the slotson each side, as shown.4 Lower the removal tool toward the bottom, andpull out the unit halfway while pressing towardsthe inside.Screw (M4X8)(commercially available)Accessory2¤• Be careful to avoid injury from the catch pins on theremoval tool.5 Pull the unit all the way out with your hands, beingcareful not to drop it.Screwing the Faceplate on the UnitIf you want to fasten the faceplate to the main unitso that it does not fall off, screw in the providedscrews in the holes shown below.Accessory5¤• Never insert the screw in any other screw hole than the onespecified. If you screw them in another hole, it will contactand may cause damage to the mechanical parts inside theunit.

/ 32

Related manuals for Kenwood KDC-MP436U