Kenwood KDC-MP4533 Instruction Manual

Kenwood KDC-MP4533 Instruction Manual Manual pdf 4 page image

4 | EnglishNotes• If you experience problems during installation,consult your Kenwood dealer.• When you purchase optional accessories, checkwith your Kenwood dealer to make sure that theywork with your model and in your area.• If the unit fails to operate properly, press the Resetbutton. The unit returns to factory settings whenthe Reset button is pressed.• Press the reset button if the disc auto changer failsto operate correctly. Normal operation should berestored.• The characters which can be displayed by thisunit are A-Z 0-9 @ " ‘ ` % & * + – = , . / \ < > [ ] ( ) : ;^ - { } | ~ .• The illustrations of the display and the panelappearing in this manual are examples used toexplain more clearly how the controls are used.Therefore, what appears on the display in theillustrations may differ from what appears on thedisplay on the actual equipment, and some of theillustrations on the display may be inapplicable.Cleaning the UnitIf the faceplate of this unit is stained, wipe it with adry soft cloth such as a silicon cloth.If the faceplate is stained badly, wipe the stain offwith a cloth moistened with neutral cleaner, thenwipe it again with a clean soft dry cloth.• Applying spray cleaner directly to the unit may affect itsmechanical parts. Wiping the faceplate with a hard clothor using a volatile liquid such as thinner or alcohol mayscratch the surface or erases characters.Cleaning the Faceplate TerminalsIf the terminals on the unit or faceplate get dirty,wipe them with a dry, soft cloth.About DAB Tuner control(KDC-MP4533/MP4033/MP4033S)Refer to A group on the Instruction manual of DABTuner KTC-9090DAB (optional accessory) for thecontrol method of DAB Tuner function.However, the following control methods of thefunction for this unit may be differed from theInstruction manual; therefore, refer to the followingsupplemental instruction.1. Select the preset band for Auto EnsembleMemory Entry.2. Press the [AME] button for at least 2 seconds.Open Auto Ensemble Memory Entry.After memory storage is finished, the number ofthe pre-set buttons and the ensemble label aredisplayed.and inAt the operation to press [DISP] button, use [AUTO]button instead.This function cannot be used.The marking of products using lasers(Except for some areas)CLASS 1LASER PRODUCTThe label is attached to the chassis/case and saysthat the component uses laser beams that havebeen classified as Class 1. This means that the unitis utilizing laser beams that are of a weaker class.There is no danger of hazardous radiation outsidethe unit.Reset button