Kenwood KDC-MP8017 Instruction Manual

Also see for KDC-MP8017: Service manual

You can change the display used when listening to the radio.Changing the Display:Each time you press the DISP button, the display changes asfollows:Station frequencySNPS name (only when being preset)Switching Display for TunerYou can enter up to eight characters for each name.Assigning NamesPress the NAME.S button.The name of the station is stored in memory, and the StationName Preset mode ends.Also, if you make no input for 10 seconds, the name will bestored up to the point that you have entered, and the modeends.• You can assign names to up to 32 FM stations and 16 AMstations.• All the station names will be erased if you press the Resetbutton.• If you want to change the name of a station, first display thename of the station (following steps 1 and 2 above), thenchange the letter(s) that you want by following steps 3 and 4.NOTE6NOTE— 17 —You can assign names to radio stations with the Station PresetMemory. Up to 32 FM stations and 16 AM stations can beassigned names.Adjust the frequency to the station whose name you want toenter.Press the NAME.S button for at least two seconds."NAME SET" is displayed once the station name preset modeis entered.The cursor will blink in the position where letters are entered.Press either the 4 or ¢ button to move the cursor to thedesired position.The 4 button moves the cursor to the left, and the ¢button to the right.Each time the 38 button is pressed, the characters to beentered change as listed below.Press the FM or AM button to display the desired character.Characters that can be displayed are as follows.Continue steps 3 and 4 until all the characters are chosen forthe name.5Alphabet (upper case): A ~ ZAlphabet (lower case): a ~ zNumerals and symbols: 0~9 @ ” ‘ ` % & * + - = , . / \ < > [ ]Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ flâ ä ê ë î ï ô ö û ü ñ ç © Æ › fi4321Station Name Preset (SNPS)Recalling a Preset Station:Press the preset station button (#1-6) for the desired station.The number of the recalled station is displayed.