• When replacing a fuse, only use a new onewith the prescribed rating. Using a fuse withthe wrong rating may cause your unit tomalfunction. on hot places such as above thedashboard.• To prevent a short circuit when replacing afuse, first disconnect the wiring harness.• If you have difficulty in installing this unit inyour vehicle, contact your Kenwood dealer.• If it doesn’t seem to be working properly,first press the Reset button. If themalfunction persists, consult your Kenwooddealer.• Some car stereos cause the sound of thetuner to make for a moment when anengine is activated.• The reception of the tuner may be reduceda little if the KDC-C467FM is used.• If the sound is lower than the tuner sound,raise up the volume level of the CD withusing the receiver.• Do not use your own screws. Use only thescrews provided. If you use the wrongscrews, you could damage the unit.NOTE— 3 —Cleaning the UnitIf the front panel gets dirty, turn off thepower and wipe the panel with a dry siliconcloth or soft cloth.Do not use hard cloths or paint thinner,alcohol, or other volatile solvents. These maydamage external surfaces or removeindicator characters.Lens FoggingRight after you turn on the car heater in coldweather, dew or condensation may form onthe lens in the CD player of the unit. Calledlens fogging, CDs may be impossible to play.In such a situation, remove the disc and waitfor the condensation to evaporate. If the unitstill does not operate normally after a whilst,consult your Kenwood dealer.The marking of products using lasers(Except for some areas)The label is attached to the chassis/case andsays that the component uses laser beamsthat have been classified as Class 1. It meansthat the unit is utilizing laser beams that areof a weaker class. There is no danger ofhazardous radiation outside the unit.CLASS 1LASER PRODUCT2CAUTIONSafety PrecautionsC D A U T O C H A N G E R C O N T R O L L E RREPRDM3- +4 ¢PWR' R D M R E PT R A C K D I S C8/M H zDISCT R A C KFREQLEVELReset buttonTake the following precautions toprevent fire and avoid personal injury:• When extending the ignition cable, batterycable, or ground cable, use 0.75mm2(AWG18) or larger automotive grade cable toavoid cable deterioration or damage to thecovering.• Check that no metal objects (coins, tools,etc.) are left inside the unit to avoid shortcircuits.• If you smell or see smoke, turn the power offimmediately and consult your Kenwooddealer.• Do not touch the liquid crystal fluid if the LCDis damaged or broken due to shock. Theliquid crystal fluid may be dangerous to yourhealth or even fatal.If the liquid crystal fluid from the LCDcontacts your body or clothing, wash it offwith soap immediately.Take the following precautions tokeep the unit in proper working order.• Be sure the unit is connected to a 12V DCpower supply with a negative groundconnection.• Do not open the top or bottom cover.• Do not install the unit in places it is exposedto direct sunlight, high heat or humidity,water may splash over it, or dust exists.2CAUTION2WARNING