Kenwood KDC-U453 Instruction Manual

Contents

3ENGLISHSafetyWARNINGStop the car before operating the unit.Important to know...To prevent a short circuit, never put orleave any metallic objects (such as coins ormetal tools) inside the unit.Caution: Adjust the volume so that youcan hear sounds outside the car. Drivingwith the volume too high may cause anaccident.Condensation: When the car is air-conditioned, moisture may collect on thelaser lens. This may cause disc read errors.In this case, remove the disc and wait forthe moisture to evaporate.This unit can only play the CDs with:The illustrations in this manual areexamples used to explain more clearlyhow the controls are used. Therefore, whatappears on the illustrations may differ fromwhat appears on the actual equipment.A USB connection cable, CA-U1EX(max.: 500 mA) (optional accessory) isrequired for connecting a USB device.You can connect an Apple iPod/iPhonewith .The word “iPod” appearing in this manualindicates the iPod or iPhone connectedto this unit with a connection cable,KCA-iP102 (optional accessory).If you experience problems duringinstallation, consult your Kenwood dealer.When you purchase external components,check with your Kenwood dealer to makesure that they work with your model and inyour area.Detailed information and notes about theplayable audio files are stated in an onlinemanual on the following site:www.kenwood.com/cs/ce/audiofile/Remote controller (RC-405) is equippedfor .can also be remotelycontrolled with an optionally purchasedremote controller.MaintenanceCleaning the unit: Wipe off the dirt on the panel with a dry silicon or soft cloth. Failure toobserve this precaution may result in damage to the monitor or unit.Cleaning the connector: The unit may not functionproperly if the connectors between the unit and faceplateare dirty. Detach the faceplate and clean the connectorwith a cotton swab gently, being careful not to damagethe connector.Handling discsDo not touch the recording surface of the disc.Do not stick tape etc. on the disc, or use a disc with tape stuck on it.Do not use any accessories for the disc.Clean from the center of the disc and move outward.Clean the disc with a dry silicon or soft cloth. Do not use any solvents.When removing discs from this unit, pull them out horizontally.Remove the rims from the center hole and disc edge before inserting a disc.Connector (on the reverseside of the faceplate)