24 EnglishInstallation/connectionPart list:A Faceplate ...................................................................(×1)B Escutcheon ..............................................................(×1)C Mounting sleeve...................................................(×1)D Wiring harness .......................................................(×1)E Removal tool .......................................................... (×2)F Flat head screw (for Nissan cars).................(×4)G Round head screw (for Toyota cars) .........(×4)Basic procedure1 Remove the key from the ignition switch,then disconnect the · terminal of thecar battery.2 Make proper input and output wireconnections.\ (page 26)3 Install the unit to your car.\ (page 27)4 Reconnect the · terminal of the carbattery.5 Reset the unit. (page 4)¤Warning■■ The unit can only be installed in a car with a12 V DC power supply, negative ground.■■ If you connect the ignition wire (red) andthe battery wire (yellow) to the car chassis(ground), you may cause a short circuit,that in turn may start a fire. Always connectthose wires to the power source runningthrough the fuse box.■■ Disconnect the battery’s negative terminaland make all electrical connections beforeinstalling the unit.■■ Insulate unconnected wires with vinyl tapeor other similar material. To prevent a shortcircuit, do not remove the caps on the endsof the unconnected wires or the terminals.■■ Be sure to ground this unit to the car’schassis again after mounting.■■ If the power is not turned ON (“PROTECT”is displayed), the speaker wire may have ashort-circuit or touched the chassis of thevehicle and the protection function mayhave been activated. Therefore, the speakerwire should be checked.¤Caution■■ If your car’s ignition key switch does nothave an ACC position, connect the ignitionwires to a power source that can be turnedon and off with the ignition key. If youconnect the ignition wires to a constant-voltage power source, as with battery wires,the battery may die.■■ Do not use your own screws. Use only thescrews provided.■■ Install this unit in the console of yourvehicle. Make sure the faceplate will not hitthe lid of the console (if any) when closingand opening.■■ After the installing the unit, check whetherthe brake lamps, blinkers, wipers, etc. on thecar are working properly.■■ Mount the unit so that the mounting angleis 30° or less.■■ If the fuse blows, first make sure the wiresare not touching other parts to cause ashort circuit, and then replace the old fusewith one with a new the same rating.■■ Connect the speaker wires correctly to thecorresponding terminals. The unit may bedamaged or fail to work if you share the ·wires or ground them to any metal part inthe car.■■ When only two speakers are beingconnected to the system, connect theconnectors either to both the front outputterminals or to both the rear outputterminals (do not mix front and rear).
