Kenwood KDC-V7017 Instruction Manual

If you have preset the name of a disc that you want to listen toin the disc changer, you can look for it by name and startplaying it.Press the DNPP button on the remote."DNPP" will appear in the display, and the disc name presetplay mode is entered.The names of all the discs in the disc changer will appearsuccessively in the display for five seconds each.Discs whose names have not been preset will appear as "NONAME" in the display.• This function can only be used in disc changers that weremanufactured or sold as of 1997. Also note that some unitsNOTE1Disc Name Preset Play (DNPP)(Function of Remote)Press the NAME.S button.The disc name is stored and the disc name preset mode iscanceled.If you make no entry in a 10-second period, the name will bestored with the characters input so far.• The number of discs whose names can be stored will differdepending on the disc changer that is connected. Please seeyour disc changer manual for details.Up to 30 CDs can be registered with this unit.• Discs are identified by their total length and number of tracks. Ifanother disc happens to have the same specifications as onethat you have already stored a name for, the name will bedisplayed for it, too.• If you want to change the name of a disc, repeat steps 1 and 2to display the name, and then repeat steps 3 and 4 to input thechanges.• Pressing the reset button erases the disc names stored in thisunit, but does not erase the names stored in a disc changer.NOTE6Store the names of discs to be displayed when played.Play the disc whose name you want to preset.• This function is not available for disc changers that do notfeature the Disc Name Preset function.• The disc name preset function cannot be used when theMagazin random play and disc title or track title is displayed.Press the NAME.S button for at least two seconds."NAME SET" is displayed and the disc name preset mode isentered.The cursor blinks in the position where character input can bemade.Press either the 4 or ¢ button to move the cursor to thedesired position.The 4 button moves the cursor to the left, and the ¢button to the right.Each time the 38 button is pressed, the characters to beentered change as listed below.Press the DISC + or DISC– button to display the desiredcharacter.Characters that can be displayed are as follows.Continue steps 3 and 4 until all the characters are chosen forthe name.You can enter up to 12 characters for each name.NOTE5Alphabet (upper case): A ~ ZAlphabet (lower case): a ~ zNumerals and symbols: 0~9 @ ” ‘ ` % & ∗ + - = , . / \ < > [ ]Special characters: á à é è í ì ó ò ú ù Ñ Ç ® ß ‹ fl â ä êë î ï ô ö û ü ñ ç © Æ › fi432NOTE1Presetting Disc Names (DNPS)CD/External disc control features— 20 —English