Kenwood KDC-W5037 Instruction Manual

Kenwood KDC-W5037 Instruction Manual Manual pdf 12 page image

12 | EnglishTuner featuresFunction of remote controlDirect Access TuningEntering the frequency and tuning.1 Select the bandPress the [FM] or [AM] button.2 Enter Direct Access Tuning modePress the [DIRECT] button on the remotecontrol."– – – –" is displayed.3 Enter the frequencyPress the number buttons on the remotecontrol.Example:Desired frequency Press button92.1 MHz (FM) [0], [9], [2], [1]810 kHz (AM) [0], [8], [1], [0]Cancelling Direct Access TuningPress the [DIRECT] button on the remotecontrol.⁄• You can enter the FM band frequency in steps of aminimum of 0.1 MHz.Station Preset MemoryPutting a station in the memory.1 Select the bandPush the Control knob towards [FM] or [AM].2 Select the frequency to put in the memoryPush the Control knob towards [4] or [¢].3 Put the frequency in the memoryPress the desired [1] — [6] button for at least 2seconds.The preset number display blinks 1 time.On each band, 1 station can be put in the memoryon each [1] — [6] button.Auto Memory EntryPutting stations with good reception in the memoryautomatically.1 Select the band for Auto Memory EntryPush the Control knob towards [FM] or [AM].2 Open Auto Memory EntryPress the [AME] button for at least 2 seconds."A-MEMORY" is displayed.When 6 stations that can be received are put in thememory Auto Memory Entry closes.⁄• When the (page 23) is ON,only RDS stations are put in the memory.• When Auto Memory Entry is done in the FM2 band, theRDS stations preset in the FM1 band are not put in thememory.Likewise, when Auto Memory Entry is done in the FM3band, RDS stations preset in FM1 or FM2 are not put inthe memory.Preset TuningRecalling the stations in the memory.1 Select the bandPush the Control knob towards [FM] or [AM].2 Recall the stationPress the desired [1] — [6] button.