Kenwood KDC-W534U Instruction Manual

Kenwood KDC-W534U Instruction Manual Manual pdf 36 page image

36 | EnglishAccessories/ Installation ProcedureAccessories1..........12..........23..........14..........25..........16..........1Installation Procedure1. To prevent short circuits, remove the key fromthe ignition and disconnect the - terminal ofthe battery.2. Make the proper input and output wireconnections for each unit.3. Connect the wire on the wiring harness.4. Take Connector B on the wiring harness andconnect it to the speaker connector in yourvehicle.5. Take Connector A on the wiring harness andconnect it to the external power connector onyour vehicle.6. Connect the wiring harness connector to theunit.7. Install the unit in your car.8. Reconnect the - terminal of the battery.9. Press the reset button.• If the power is not turned ON (or it is ON, but will be OFFimmediately), the speaker wire may have a short-circuitor touched the chasis of the vehicle and the protectionfunction may have been activated. Therefore, the speakerwire should be checked.• If your car is not prepared for this special connection-system, consult your Kenwood dealer.• Only use antenna conversion adapters (ISO-JASO) whenthe antenna cord has an ISO plug.• Make sure that all wire connections are securely made byinserting jacks until they lock completely.• If your vehicle’s ignition does not have an ACC position,or if the ignition wire is connected to a power sourcewith constant voltage such as a battery wire, the powerwill not be linked with the ignition (i.e., it will not turn onand off along with the ignition). If you want to link theunit’s power with the ignition, connect the ignition wireto a power source that can be turned on and off with theignition key.• If the fuse blows, first make sure that the wires have notcaused a short circuit, then replace the old fuse with onewith the same rating.• Insulate unconnected wires with vinyl tape or othersimilar material. To prevent short circuits, also do notremove the caps on the ends of the unconnected wiresor the terminals.• Connect the speaker wires correctly to the terminals towhich they correspond. The unit may receive damage orfail to work if you share the - wires and/or ground themto any metal part in the car.• After the unit is installed, check whether the brake lamps,indicators, wipers, etc. on the car are working properly.• If the console has a lid, make sure to install the unit sothat the faceplate does not hit the lid when closing andopening.• Mount the unit so that the mounting angle is 30° or less.